Please help identify this Silvertone

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Guest
Unregistered

12-17-2008, 04:51 PM

Thanks. Yes, they're close but no match. Someone today told me it might be a 7181, but I can't find another picture of one to confirm that. All I know is that the chassis has a serial number on it, 7S-1089. Also, the receiver takes these seven tubes: 5Y3, 6C5, 6F6, 6K7, 6K7, 6L7, 6Q7

« Next Oldest | Next Newest »

Messages In This Thread

Please help identify this Silvertone - by Guest - 12-16-2008, 09:43 PM

Re: Please help identify this Silvertone - by BDM - 12-16-2008, 11:57 PM

Re: Please help identify this Silvertone - by Guest - 12-17-2008, 04:51 PM

Re: Please help identify this Silvertone - by rghines1 - 12-17-2008, 07:11 PM

Re: Please help identify this Silvertone - by Guest - 12-18-2008, 10:12 PM

Re: Please help identify this Silvertone - by Guest - 07-13-2010, 05:13 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 2476 online users. [Complete List]
» 3 Member(s) | 2473 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me