[Kekoa]

Morzh,  I actually ended up doing something similar to that.  I took a small loop of hook-up wire and soldered it to one of the connections on the original electrolytic can.  That gave me a place I could use as an anchor point for a zip-tie.  So the end result is slightly different from the picture I posted.

I thought about trying to stuff them in the original can, but I don't see how they would fit.  It would have to hold a 20uF, and two 10uF electrolytics, and the new ones are just too big to fit in the old can.  The second can was also a  20/10/10 configuration, but the 10uF's were in parallel, so I replaced them with a single 20uF.  That saved a little space.