Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

New to Phorum and a Philco 38
#9

 The #19 uses a six pin base, so they may have used a #41 or #42 in it's place. The #30 has a four pin base, as does the two #32 tubes, if there was a type 6 tube in your set that was a four pin ballast, which means the set was actually a 38A. The type #15 had a five pin base, the 6A8G is obviously an octal. So yes, there was some butchery that went on with this set.
Regards
Arran


Messages In This Thread
New to Phorum and a Philco 38 - by radioalfa - 11-22-2014, 10:49 PM
RE: New to Phorum and a Philco 38 - by sam - 11-23-2014, 01:19 AM
RE: New to Phorum and a Philco 38 - by Arran - 11-23-2014, 04:14 AM
RE: New to Phorum and a Philco 38 - by morzh - 11-23-2014, 10:24 AM
RE: New to Phorum and a Philco 38 - by klondike98 - 11-23-2014, 10:35 AM
RE: New to Phorum and a Philco 38 - by radioalfa - 11-23-2014, 11:57 AM
RE: New to Phorum and a Philco 38 - by radioalfa - 11-24-2014, 10:04 PM
RE: New to Phorum and a Philco 38 - by Arran - 11-25-2014, 03:38 AM
RE: New to Phorum and a Philco 38 - by radioalfa - 11-25-2014, 10:28 PM
RE: New to Phorum and a Philco 38 - by Arran - 11-26-2014, 01:00 AM
RE: New to Phorum and a Philco 38 - by radioalfa - 11-26-2014, 08:15 AM



Users browsing this thread: 1 Guest(s)