hi new to phorum

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

hi new to phorum

JimZ
Member

Posts: 114
Threads: 2
Joined: Jan 2014
City: Southport NC

11-27-2014, 06:03 PM

Welcome. Looks to be a nice enough radio maybe from 50's.
Check the rear dust cover for any numbers or perhaps inside the case and maybe you can
find the model here

http://www.radiomuseum.org/m/philco_gb_en_1.html

Looking quickly at sold British Philco on the Ebay there I couldn't find an exact match so maybe a rear picture will help someone here familiar with the chassis

Find

« Next Oldest | Next Newest »

Messages In This Thread

hi new to phorum - by Fienulla fairylocks - 11-27-2014, 01:14 PM

RE: hi new to phorum - by Fienulla fairylocks - 11-27-2014, 05:43 PM

RE: hi new to phorum - by JimZ - 11-27-2014, 06:03 PM

RE: hi new to phorum - by Fienulla fairylocks - 11-27-2014, 06:31 PM

RE: hi new to phorum - by Ron Ramirez - 11-27-2014, 07:04 PM

RE: hi new to phorum - by Fienulla fairylocks - 11-27-2014, 08:45 PM

RE: hi new to phorum - by Arran - 11-29-2014, 02:05 AM

RE: hi new to phorum - by Radioroslyn - 11-30-2014, 02:30 PM

hi new to phorum - by sam - 11-27-2014, 02:42 PM

RE: hi new to phorum - by Fienulla fairylocks - 11-27-2014, 05:42 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio. This is a shame because this should be a good performer. 2A...captainclock1988 — 03:43 PM
Philco 42-390, code 121 speaker
Using a 5W 1.5k ceramic resistor in place of the field coil and using a 4 ohm PM speaker, I was able to bring the radi...Stevelog — 02:57 PM
Philco 60 Squealing
I have taken out the 2nd IF and found a problem or not. I believe the coils are litz wire. There is a very small strand ...dconant — 02:13 PM
Philco 6K7
I am restoring a Philco 37-60. The am reception is very good, but the shortwave is very weak. Run 6 Philco removes the g...bobbyd1200 — 01:35 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio. This is a shame because this should be a good performer. 2A5...MrFixr55 — 06:48 AM

Who's Online

There are currently 4793 online users. [Complete List]
» 4 Member(s) | 4789 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me