xf 19

Thread Rating:

xf 19

Guest
Unregistered

11-30-2008, 07:22 PM

I will take some pictures tomorrow and post them tomorrow, if possible Thanks for the reply! Turtle

« Next Oldest | Next Newest »

Messages In This Thread

xf 19 - by Guest - 11-19-2008, 10:33 PM

Re: xf 19 - by Texasrocker - 11-20-2008, 02:39 AM

Re: xf 19 - by Guest - 11-30-2008, 07:22 PM

Re: xf 19 - by Guest - 12-03-2008, 01:35 AM

Re: xf 19 - by Ron Ramirez - 12-03-2008, 07:50 AM

Re: xf 19 - by Guest - 12-03-2008, 10:03 PM

Re: xf 19 - by Chuck Schwark - 12-03-2008, 10:11 PM

Re: xf 19 - by Ron Ramirez - 12-03-2008, 10:52 PM

Re: xf 19 - by Guest - 12-09-2008, 12:44 AM

Re: xf 19 - by Ron Ramirez - 12-09-2008, 02:13 PM

Re: xf 19 - by Guest - 12-14-2008, 09:15 PM

Users browsing this thread: 3 Guest(s)

Recent Posts
Rusty Tuning Condenser
Hello Rob. I've also heard of soaking the tuning cap in automatic transmission fluid. This was an old trick we used to...GarySP — 06:14 PM
Rusty Tuning Condenser
Gary, I once had a tuning cap that had a thick coat of kitchen grease and grime. So I had heard about brake cleaner bei...RodB — 06:03 PM
Rusty Tuning Condenser
I've put tuning caps with mica removed and vanes wide open in the dishwasher and ran through a cycle. When the dishwash...GarySP — 05:42 PM
Rusty Tuning Condenser
I do not think Philco 91 used pot metal for the tuning cap. Also, in 1930-s pot metal did not have iron, being mostly co...morzh — 04:56 PM
38-10T chassis Restoration begins
Rich do you dunk the whole razor in there with it turned on to get a good mix? :lol:dconant — 04:48 PM
Rusty Tuning Condenser
David, RodB says to watch out for pot metal as it might dissolve in vinegar. I think there might be some in there. I thi...dconant — 04:40 PM
Rusty Tuning Condenser
Give the tuner a good wash in Dawn and hot water. Then set tuner in a plastic container and cover with vinegar let soak ...David — 12:53 PM
Rusty Tuning Condenser
If you have rust between the vanes, I wonder how you get the NJ in between, and how you then wipe it off.morzh — 12:02 PM
Philco 60 Squealing
If the noise is still there, the OPT might just be OK. Or so we hope.morzh — 12:01 PM
Philco 60 Squealing
You would probably be replacing the OPT.RodB — 10:54 AM

Who's Online

There are currently 3306 online users. [Complete List]
» 2 Member(s) | 3304 Guest(s)