Philco radio from 1971 Ford F100

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Guest
Unregistered

12-03-2008, 10:30 PM

The radio does the same thing without the engine running. I don't know what a transistor ignition is so I don't know if it has one. The antenna is mounted on the top of the right quarter pannel and has a cable that goes through the fire wall and in to the radio. I tested the voltage to the radio as you suggested and it is getting 12 volts. So far, all I've done is remove the radio and the cover and blew the dust out. The dials and buttons seem to be working. Then I plugged in the speaker, antenna, and power with the engine off and nothing changed.

I really appreciate your input.

Steve L.

« Next Oldest | Next Newest »

Messages In This Thread

Philco radio from 1971 Ford F100 - by Guest - 12-02-2008, 11:17 PM

Re: Philco radio from 1971 Ford F100 - by exray - 12-02-2008, 11:50 PM

Re: Philco radio from 1971 Ford F100 - by Guest - 12-03-2008, 01:26 AM

Re: Philco radio from 1971 Ford F100 - by BILL - 12-03-2008, 03:59 PM

Re: Philco radio from 1971 Ford F100 - by Guest - 12-03-2008, 10:30 PM

Re: Philco radio from 1971 Ford F100 - by BILL - 12-04-2008, 11:16 AM

Re: Philco radio from 1971 Ford F100 - by Guest - 12-04-2008, 03:09 PM

Re: Philco radio from 1971 Ford F100 - by BILL - 12-04-2008, 07:51 PM

Re: Philco radio from 1971 Ford F100 - by Guest - 12-05-2008, 01:21 PM

Re: Philco radio from 1971 Ford F100 - by BILL - 12-05-2008, 03:53 PM

Re: Philco radio from 1971 Ford F100 - by Guest - 12-05-2008, 11:24 PM

Re: Philco radio from 1971 Ford F100 - by Guest - 10-30-2009, 01:40 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 5980 online users. [Complete List]
» 1 Member(s) | 5979 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me