Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Dynakit Stereo 70 Refurb
#34

Very nice Joe!
I've read a lot about the 70 and know there are many mods that can be done. They seem to be a very popular amplifier.
I've read where the 6GH8's are a good replacement for the 7199's. As you know, many tubes like the 7199's are getting up there in price. Many people think they sound as good or better too which is a big plus
I did a similar driver swap in a set of Heathkit W5M amplifiers many years ago using 6CG7's in place of the 12Au7's. In that swap there was a big change in sound. I used them for about 3 or 4 years. The W5M's could be hard on tweeters as many Williamson designs were. I found out there were mods to help prevent this, but I had bought and restored other tube amplifiers by then and ended up selling them.
I'd like to listen to a ST70 sometime.

Merry Christmas!


Messages In This Thread
Dynakit Stereo 70 Refurb - by Joeztech - 08-24-2014, 07:01 AM
RE: Dynakit Stereo 70 Refurb - by Phlogiston - 08-24-2014, 10:01 AM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 08-24-2014, 10:34 AM
RE: Dynakit Stereo 70 Refurb - by codefox1 - 08-25-2014, 01:30 AM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 08-25-2014, 06:31 AM
RE: Dynakit Stereo 70 Refurb - by Phlogiston - 08-25-2014, 10:07 AM
RE: Dynakit Stereo 70 Refurb - by gregb - 08-25-2014, 05:15 PM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 08-26-2014, 04:32 PM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 08-30-2014, 03:45 PM
RE: Dynakit Stereo 70 Refurb - by Ron Ramirez - 08-31-2014, 07:49 AM
RE: Dynakit Stereo 70 Refurb - by Pillo69 - 08-31-2014, 10:21 AM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 09-02-2014, 09:10 AM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 09-04-2014, 08:10 AM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 09-05-2014, 01:17 PM
RE: Dynakit Stereo 70 Refurb - by Ron Ramirez - 09-05-2014, 01:44 PM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 09-05-2014, 02:09 PM
RE: Dynakit Stereo 70 Refurb - by Ron Ramirez - 09-05-2014, 02:13 PM
RE: Dynakit Stereo 70 Refurb - by Arran - 09-07-2014, 02:08 AM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 09-07-2014, 06:46 AM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 09-08-2014, 02:20 PM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 09-08-2014, 05:34 PM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 09-13-2014, 10:46 AM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 09-14-2014, 07:54 PM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 09-17-2014, 04:07 PM
RE: Dynakit Stereo 70 Refurb - by Ron Ramirez - 09-18-2014, 07:48 AM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 09-18-2014, 11:57 AM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 09-19-2014, 02:38 PM
RE: Dynakit Stereo 70 Refurb - by Pillo69 - 09-19-2014, 07:39 PM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 09-21-2014, 07:23 PM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 09-23-2014, 05:25 PM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 11-15-2014, 08:06 AM
RE: Dynakit Stereo 70 Refurb - by thirtiesradio - 12-22-2014, 09:04 PM
RE: Dynakit Stereo 70 Refurb - by Joeztech - 12-23-2014, 07:31 AM
RE: Dynakit Stereo 70 Refurb - by thirtiesradio - 12-23-2014, 12:53 PM
RE: Dynakit Stereo 70 Refurb - by Phlogiston - 04-18-2015, 06:36 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM
HiFi (Chifi) tube amp build - but my own design.
Tim Well...a chassis is metal. Magnetic or not, it does not matter. A transformer has some hum to it. It is natural. Th...morzh — 08:40 PM
Hickok AC51 tube tester
I thought the 83 tube was bad because it looked white but it tests strong. Blue gassy though. I checked the fuse, it was...martinj — 08:37 PM

[-]
Who's Online
There are currently no members online.

>