Here we go with a Brand Z 9-S-262
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand
State, Province, Country: Indiana
The Riders info included the alignment procedure. Thirtiesradio, does your Zenith service manual include an under-chassis drawing for the 9-S-262, or did Zenith just not produce any of those? I'm slowly making progress replacing caps and resistors, but a factory under-chassis drawing would sure help.
I did download Geoff's handmade under-chassis drawing, which has helped.
I wouldn't even mention it if this chassis had not been molested...but since it has been hacked, I'd like to make sure the wires are connected as they should be. As one example of a hack, a previous owner had the suppressor grid of the 6K7 RF amp connected to the screen grid of the 6L7.
--
Ron Ramirez
Ferdinand IN
Messages In This Thread
RE: Here we go with a Brand Z 9-S-262 - by Ron Ramirez - 12-24-2014, 04:23 PM
Users browsing this thread: 2 Guest(s)
|
Recent Posts
|
Philco 46-480 Electronic Restoration
|
The sleeving for the transformer arrived early, so I went ahead and finished reassembling. The chassis looks far better ...jrblasde — 10:15 PM |
Philco 610B oscillator wiring
|
I don't know what you are referring to when you say "tube cathode ground". Ground is a connection to the chass...RodB — 05:56 PM |
Zenith H725
|
Good points, Arran. I haven't encountered this problem with any other radio (all earlier vintages), so am learning here....EdHolland — 05:32 PM |
Zenith H725
|
Ed;
One thing that I will say about these is that Brand Z was considerate enough to make these mica caps easily acces...Arran — 02:34 PM |
Philco 610B oscillator wiring
|
Do you know what run # your chassis is?
It took me a while to find what you were basing updates/modification on as I did...Radioroslyn — 07:34 AM |
Need to purchase some accessories for restoration of my Old Philco Radio
|
COLLEAGUES,
Thank you all for such good and important suggestions as how to find good replacement parts. I will go fo...palonso — 07:05 AM |
Zenith H725
|
Here's what the inside of AM IFT2 looked like, and the other pic shows the discs I made to take place of the mica and ke...EdHolland — 07:40 PM |
Zenith H725
|
IF2 will need replacement caps. The arcing was severe enough that the mica is pitted and holed where the HT flashed over...EdHolland — 04:04 PM |
My Philco 37-116 Restore
|
Measuring from center tap like the tube voltages show. Cap 127 is isolated from ground. Cap 127 shown in upper left of p...dconant — 08:05 AM |
My Philco 37-116 Restore
|
Are you measuring relative to the centertap or the GND?morzh — 11:57 PM |
Who's Online
|
There are currently 758 online users. [Complete List] » 2 Member(s) | 756 Guest(s)
|
|
|

|