Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My Brand Z G725
#4

Thanks Ron,

I swapped each tube with known good ones, one at a time. I resoldered each terminal of the vol control. Could it be the vol control itself?

Eric
The Villages, FL
Member: Philco Phorum, ARF, ARCI & Radiomuseum.org



Messages In This Thread
My Brand Z G725 - by Eric Adams - 12-25-2014, 12:53 AM
RE: My Brand Z G725 - by OldRestorer - 12-25-2014, 07:42 AM
RE: My Brand Z G725 - by Ron Ramirez - 12-25-2014, 09:25 AM
RE: My Brand Z G725 - by Eric Adams - 12-25-2014, 11:19 AM
RE: My Brand Z G725 - by Ron Ramirez - 12-25-2014, 03:45 PM
RE: My Brand Z G725 - by Jayce - 12-25-2014, 04:27 PM
RE: My Brand Z G725 - by Eric Adams - 12-25-2014, 11:40 PM
RE: My Brand Z G725 - by morzh - 12-26-2014, 01:02 AM
RE: My Brand Z G725 - by Eric Adams - 12-26-2014, 01:33 AM
RE: My Brand Z G725 - by morzh - 12-26-2014, 12:46 PM
RE: My Brand Z G725 - by Eric Adams - 12-27-2014, 01:43 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

[-]
Who's Online
There are currently no members online.

>