1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
My Brand Z G725
Jayce
Phorum Expert
*****
Posts: 2,026
Threads: 367
Joined: Jun 2010
City: Dover, OH
#6

12-25-2014, 04:27 PM
This might sound silly, but did you clean the controls? Sometimes a dirty control pot or even tube socket can cause hum as well.
No matter where you go, there you are.
Find
« Next Oldest | Next Newest »


Messages In This Thread
My Brand Z G725 - by Eric Adams - 12-25-2014, 12:53 AM
RE: My Brand Z G725 - by OldRestorer - 12-25-2014, 07:42 AM
RE: My Brand Z G725 - by Ron Ramirez - 12-25-2014, 09:25 AM
RE: My Brand Z G725 - by Eric Adams - 12-25-2014, 11:19 AM
RE: My Brand Z G725 - by Ron Ramirez - 12-25-2014, 03:45 PM
RE: My Brand Z G725 - by Jayce - 12-25-2014, 04:27 PM
RE: My Brand Z G725 - by Eric Adams - 12-25-2014, 11:40 PM
RE: My Brand Z G725 - by morzh - 12-26-2014, 01:02 AM
RE: My Brand Z G725 - by Eric Adams - 12-26-2014, 01:33 AM
RE: My Brand Z G725 - by morzh - 12-26-2014, 12:46 PM
RE: My Brand Z G725 - by Eric Adams - 12-27-2014, 01:43 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)