1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 59 Antenna Transformer
morzh
Odobenus rosmarus
*****
Posts: 15,819
Threads: 554
Joined: Oct 2011
City: Jackson, NJ
#5

12-28-2014, 06:55 PM
Same was the case here but you need to count nevertheless.
Well, I guess too late now.

When you rewound it, how did you decide how many turns you needed?


PS.

If anyone knows the capacitance of the tuning cap (meshed/open), and if we can have exact diameter of the bobbin and length of winding we could try to figure the turns.

Which part of the coil is bad, pimary (antenna side) or seondary (tube side)?
(This post was last modified: 12-28-2014, 07:19 PM by morzh.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 59 Antenna Transformer - by cparsons2391 - 12-28-2014, 11:31 AM
RE: Philco 59 Antenna Transformer - by morzh - 12-28-2014, 01:05 PM
RE: Philco 59 Antenna Transformer - by morzh - 12-28-2014, 06:55 PM
RE: Philco 59 Antenna Transformer - by morzh - 12-29-2014, 06:09 PM
RE: Philco 59 Antenna Transformer - by codefox1 - 12-30-2014, 01:14 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration