Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Help Identifying Radio
#13

I am being told it is a kit or a mismatch. The knobs are not equal on the cabinet so the chassis may not be to it.

Kirk

Times I have been electrocuted in 2021
As of 1/01/2021
AC: 4 DC: 1
Last year: 6


Messages In This Thread
Help Identifying Radio - by RoyG - 12-29-2014, 01:47 PM
RE: Help Identifying Radio - by OldRestorer - 12-29-2014, 10:46 PM
RE: Help Identifying Radio - by morzh - 12-30-2014, 12:09 AM
RE: Help Identifying Radio - by sam - 12-30-2014, 12:22 AM
RE: Help Identifying Radio - by PhilcoMike - 12-30-2014, 12:28 PM
RE: Help Identifying Radio - by RoyG - 12-30-2014, 01:42 PM
RE: Help Identifying Radio - by RoyG - 12-31-2014, 05:31 PM
RE: Help Identifying Radio - by morzh - 12-30-2014, 12:26 AM
RE: Help Identifying Radio - by OldRestorer - 12-30-2014, 11:56 AM
RE: Help Identifying Radio - by morzh - 12-31-2014, 10:35 PM
RE: Help Identifying Radio - by Joe Rossi - 12-31-2014, 11:15 PM
RE: Help Identifying Radio - by Joe Rossi - 12-31-2014, 11:42 PM
RE: Help Identifying Radio - by OldRestorer - 01-01-2015, 03:00 PM
RE: Help Identifying Radio - by sam - 01-01-2015, 06:36 PM
RE: Help Identifying Radio - by Arran - 01-01-2015, 11:44 PM
RE: Help Identifying Radio - by radiohenry - 01-02-2015, 09:26 AM
RE: Help Identifying Radio - by JimZ - 01-02-2015, 11:23 AM
RE: Help Identifying Radio - by RoyG - 01-02-2015, 01:30 PM
RE: Help Identifying Radio - by Joe Rossi - 01-02-2015, 04:12 PM
RE: Help Identifying Radio - by JimZ - 01-02-2015, 04:30 PM
RE: Help Identifying Radio - by Joe Rossi - 01-02-2015, 04:48 PM
RE: Help Identifying Radio - by RoyG - 01-12-2015, 02:41 AM
RE: Help Identifying Radio - by Arran - 01-12-2015, 04:46 AM
RE: Help Identifying Radio - by RoyG - 01-12-2015, 03:55 PM
RE: Help Identifying Radio - by Joe Rossi - 01-12-2015, 04:30 PM
RE: Help Identifying Radio - by RoyG - 01-12-2015, 05:27 PM
RE: Help Identifying Radio - by JimZ - 03-05-2015, 08:45 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently no members online.

>