Here we go with a Brand Z 9-S-262
Posts: 479
Threads: 73
Joined: Mar 2012
City: Riverside, CA
(01-09-2015, 04:24 AM)thirtiesradio Wrote: (01-08-2015, 03:30 PM)Geoff Wrote: Yes, I have the variac in there set to 110V. The only reason it is in there is because I never got around to adding a dropping resistor in series with the line cord. I'll need to do that some day .
I can't see the front Geoff, but that set of yours looks brand new from the rear! That is one clean chassis.
Thanks. Here is the thread where I restored my 9S262 that Ron had referred to:
http://www.philcoradio.com/phorum/showth...p?tid=4917
Messages In This Thread
RE: Here we go with a Brand Z 9-S-262 - by Geoff - 01-09-2015, 11:07 AM
Users browsing this thread: 6 Guest(s)
|
Recent Posts
|
trying to identify this wire type
|
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM |
trying to identify this wire type
|
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM |
Gilfillan Brothers Car Radio?
|
Hi everyone,
Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM |
trying to identify this wire type
|
Here's one source for your wire of many.
Take care and BE HEALTHY! Gary
P.S. Can't get the right color you need? I ...GarySP — 06:40 PM |
trying to identify this wire type
|
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM |
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
|
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM |
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
|
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM |
trying to identify this wire type
|
The red wire is rubber covered wire.
The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM |
trying to identify this wire type
|
Greetings Phorum members,
Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM |
Philco 60 Squealing
|
All correct shields must be in place, all tubes correct no subs of any kind.
Check any soldered, riveted ground conne...Chas — 01:24 PM |
Who's Online
|
There are currently no members online. |
|
|