pioneer sx1500td blowing fuse
Posts: 1,475
Threads: 69
Joined: Nov 2012
City: Kansas city, MO.
Well I did have all the wires connected to the amp. I did not know it was safe to leave then out of circuit. I will retry power up with just amp B+ and E which is the grounds I believe. I will also check the VR1 &2 settings. The 10 ohm and 1/2 ohm resistors are checking R 24 R28(10) R31 &33 0.5 and 0.7.
(This post was last modified: 01-10-2015, 07:12 PM by KCMike.
Edit Reason: correction
)
Messages In This Thread
RE: pioneer sx1500td blowing fuse - by KCMike - 01-10-2015, 10:01 AM
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
Need to purchase some accessories for restoration of my Old Philco Radio
|
Here is a list of resources found in our online library that you might find useful. Mike's Gobs of Knobs email addres...klondike98 — 01:46 PM |
First Radio restoration
|
Hi Tubeman,
Welcome to the Philco Phorum. Phamily Phriendly Pfun with Phine Pholks Phull of Philco Phacts. (See a p...MrFixr55 — 12:33 PM |
First Radio restoration
|
You could post in the WANTED ADs section here on the Phorum and see if anyone has an RF generator that they want to sell...klondike98 — 11:55 AM |
Zenith H725
|
Good ideas, thank you Arrange and Rich. I have the adhesive aluminum foil already and can try that immediately.
More ...EdHolland — 10:18 AM |
Graphics for majestic 1050 dial glass.
|
Murf;
I found this thread on the ARF, the first photo has a pretty good view of the dial glass.
Regards
ArranArran — 01:12 AM |
Zenith H725
|
hello Ed,
how about that speacial tape used for ducting it's like foil or how about thin piece of
aluminum roof flash...radiorich — 12:19 AM |
Zenith H725
|
Ed;
One material that I have seen, but never tried for this was material for making exhaust gaskets, it's similar to ...Arran — 11:42 PM |
Zenith H725
|
I just remembered, I have some hi temp silicone rubber material which could do the trick. Or a piece of FR4 laminate. Th...EdHolland — 08:39 PM |
Zenith H725
|
The PSU filter cap arrived today (thank you USPS!) so I will work on that later.
Meanwhile, I have the dial, speaker...EdHolland — 06:42 PM |
Philco 610B oscillator wiring
|
Thanks Terry. After checking my notes I think I recorded about -10v at the 6A7 G4/control grid. The screen grid (G3 &...Tubester — 05:59 PM |
Who's Online
|
There are currently 1541 online users. [Complete List] » 1 Member(s) | 1540 Guest(s)
|
|
|

|