Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Does anybody unkown philco?
#3

(01-12-2015, 10:43 PM)Ron Ramirez Wrote:  The chassis is a 95.

The cabinet is a Philco Highboy:
http://www.philcoradio.com/gallery/1929c.htm#e

The grille insert is, most likely, not original. Notice how it is offset to the right and is also just a bit too wide (top to bottom) for the opening? I would bet it was installed later by someone who wanted something that looked a bit more decorative than the typical tapestry grille cloth, which may have become damaged prompting this addition.
Nice detective work Ron, Was the wooden cross section on the legs offered to just some models? I checked on this one and no evidence any where ever on there  , was there  ever a speaker board for grill cloth to be attached? What would  this be worth as it sits?


Messages In This Thread
Does anybody unkown philco? - by Fred Taylor - 01-12-2015, 08:36 PM
RE: Does anybody unkown philco? - by Ron Ramirez - 01-12-2015, 10:43 PM
RE: Does anybody unkown philco? - by Fred Taylor - 01-12-2015, 10:56 PM
RE: Does anybody unkown philco? - by Ron Ramirez - 01-12-2015, 11:00 PM
RE: Does anybody unkown philco? - by Fred Taylor - 01-12-2015, 11:27 PM
RE: Does anybody unkown philco? - by Arran - 01-13-2015, 02:03 AM
RE: Does anybody unkown philco? - by DeckApe - 01-23-2015, 02:11 PM
RE: Does anybody unkown philco? - by Fred Taylor - 02-04-2015, 10:44 PM
RE: Does anybody unkown philco? - by DeckApe - 02-05-2015, 10:30 AM
RE: Does anybody unkown philco? - by Joe Rossi - 02-02-2015, 10:03 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
New Philco Repair Bench
Apparently there is a new Philco Repair Bench found at https://philcoradio.com/repairbench/ When I try to go to order a ...dconant — 12:00 PM
Philco 60 Squealing
Well, a wave trap is a trimmer in series with the coil so at the resonant frequency it provides a short to ground. This ...RodB — 10:07 AM
Philco 60 Squealing
Rod, My radio is run 7. The wave trap is on that schematic as shown in the picture. dconant — 09:21 AM
American Bosch Model 802 auto radio
Hi Arran ,  Thanks for your help with this radio.And especial thanks for letting me know to look it up under United Ame...Antipodal — 04:32 AM
Philco 60 Squealing
Usually a wave trap is for keeping IF signals from entering the antenna and from leaving the antenna. You feed an IF sig...RodB — 09:30 PM
Philco 60 Squealing
I just peaked it for the best signal at 600. NULL it for IF frequency, originally it would have been null for 500kh...Chas — 08:05 PM
Philco 60 Squealing
Wavetrap no longer matters.morzh — 05:19 PM
Philco 60 Squealing
Rod, I had checked out your suggestions but did not help. I did solder the ground rivets to the chassis as Chas suggeste...dconant — 04:52 PM
37-690 Bass Choke Replacement
Yeah, I know, Mouser and Digikey don't have "big iron" components. For some reason Philco was messing with the...Radiodial — 04:25 PM
37-690 Bass Choke Replacement
Yes, I just had to deal with that while repairing the 37-604 Philco. Exactly that value choke was gone. And the current ...morzh — 03:52 PM

[-]
Who's Online
There are currently no members online.

>