1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Chassis Hardware Source
Joe Rossi
Senior Member
****
Posts: 467
Threads: 31
Joined: Sep 2009
City: Lapeer State, Province, Country: MI
#3

02-02-2015, 11:26 AM
(02-02-2015, 11:11 AM)klondike98 Wrote:  Antique Electronic Supply has quite a bit of hardware on its site but I usually try my local Ace or True Value first.  

Thanks Bob.  I'd seen these, but I'm hardware challenged and really couldn't figure if these would be compatible with radio chassis.  I was hoping that one of the radio suppliers had an assortment pack.   Maybe I'll take a few to the Depot or Ace and try my luck.  Joe
Joe

Matthew 16:26 "For what does it profit a man if he gain the whole world, yet lose his own soul?"
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Chassis Hardware Source - by Joe Rossi - 02-02-2015, 11:08 AM
RE: Chassis Hardware Source - by klondike98 - 02-02-2015, 11:11 AM
RE: Chassis Hardware Source - by Joe Rossi - 02-02-2015, 11:26 AM
RE: Chassis Hardware Source - by klondike98 - 02-02-2015, 11:36 AM
RE: Chassis Hardware Source - by Eliot Ness - 02-02-2015, 11:38 AM
RE: Chassis Hardware Source - by Joe Rossi - 02-02-2015, 04:08 PM
RE: Chassis Hardware Source - by Steve Davis - 02-02-2015, 11:52 AM
RE: Chassis Hardware Source - by brownie45 - 02-10-2015, 10:49 AM
RE: Chassis Hardware Source - by codefox1 - 02-10-2015, 01:45 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM
Restoring Philco 96
Nice one!Stan the Man — 09:37 PM
Restoring Philco 96
I have eventually replaced the speaker and shot the video, which only shows the upper part of the dial as the hum is ver...morzh — 09:24 PM
Rogers Majestic R-646
Kinda weird to see both open Nothing weird if you remember that this radio is about 100 years old  :)Vlad95 — 07:49 PM
Philco 42-345 Restoration/Repair
I believe I'm making progress, resistors have been rechecked and corrected, removed that ugly blue capacitor and more wi...osanders0311 — 07:38 PM
Philco Model 16 wiring question
Thanks Morzh Yes I recapped everything and replaced almost all the resistors as well. I redid #99 with .015 safety ca...bobclausen — 07:11 PM
Philco Model 16 wiring question
Well...pull out every single load of the transformer. For every winding. Unsolder if needed. Then re-do your dim bulb....morzh — 07:02 PM
Rogers Majestic R-646
Kinda weird to see both open, but once you get it up and running, really pay attention to your sound. Listen for loud cr...TV MAN — 06:59 PM

[-]
Who's Online
There are currently 969 online users. [Complete List]
» 1 Member(s) | 968 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration