1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 37-630 questions
Ovila Joseph
Junior Member
**
Posts: 7
Threads: 2
Joined: Jan 2015
City: Michigan
#3

02-11-2015, 10:11 PM
(02-11-2015, 03:17 PM)klondike98 Wrote:  Welcom to the Phorum!  There's a schematic on Audiophool's Philco page.  If you can't get the DJVU file to open let me know and I can post a pdf of it. Looks like the Tone Control is also the On-Off swithch (part #59).  Once turned on it appears further turning would adjust the tone by adding in different capacitors.  Perhaps someone with a 37-630 can say for certain.  

Your best bet for a Philco replacement is to put an ad in the "Wanted Ads" section.  

Hi Bob.

Could you please post the PDF? That file won't open for me.

Thank you
Joe
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 37-630 questions - by Ovila Joseph - 02-11-2015, 02:19 PM
RE: Philco 37-630 questions - by klondike98 - 02-27-2015, 10:42 AM
RE: Philco 37-630 questions - by Ovila Joseph - 02-27-2015, 07:33 PM
RE: Philco 37-630 questions - by klondike98 - 02-27-2015, 08:19 PM
RE: Philco 37-630 questions - by Ovila Joseph - 02-28-2015, 10:25 PM
RE: Philco 37-630 questions - by klondike98 - 03-01-2015, 05:16 PM
RE: Philco 37-630 questions - by Ron Ramirez - 03-02-2015, 08:41 AM
RE: Philco 37-630 questions - by mikethedruid - 08-15-2015, 07:48 PM
RE: potentiometer for a philco 37-630 - by Ovila Joseph - 02-11-2015, 10:11 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration