Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Zenith H725-Problem Solved!
#4

(02-21-2015, 01:37 AM)Eric Adams Wrote:  ....... I replaced the 2nd IF can-no change. I did find out that if I jump from where the signal stopped (pin 6 of 12BA6, 2nd IF) to pin 6 of the 12AU6 Limiter, I get great volume and all AM stations up and down the dial ....

Looks like you should be looking at T3, the third IF transformer.  You'd probably get similar results jumping from pin 6 of the second IF to pin 1 of the Limiter.

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"


Messages In This Thread
Zenith H725-Problem Solved! - by Eric Adams - 02-21-2015, 01:37 AM
RE: Zenith H725 - by Radioroslyn - 02-21-2015, 07:38 AM
RE: Zenith H725 - by Joe Rossi - 02-21-2015, 07:40 AM
RE: Zenith H725 - by Eliot Ness - 02-21-2015, 07:43 AM
RE: Zenith H725 - by Eric Adams - 02-21-2015, 10:12 AM
RE: Zenith H725 - by Ron Ramirez - 02-21-2015, 10:31 AM
RE: Zenith H725 - by Eric Adams - 02-21-2015, 10:47 AM
RE: Zenith H725 - by Eric Adams - 02-21-2015, 12:06 PM
RE: Zenith H725-Problem Solved! - by Ron Ramirez - 02-21-2015, 12:08 PM
RE: Zenith H725-Problem Solved! - by Eric Adams - 02-21-2015, 02:25 PM



Users browsing this thread:
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently 3612 online users. [Complete List]
» 1 Member(s) | 3611 Guest(s)
Avatar

>