1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
46-421 capacitor
klondike98
Phorum Moderator
******
Posts: 5,088
Threads: 270
Joined: Nov 2012
City: Wilsonville State, Province, Country: OR
#2

02-22-2015, 10:31 PM
I've just restuffed the old cap and kept the wire wrapped around it.  Here's a 42-322 with one of those caps.  There is one of those yellow film caps inside the paper cap body; note the wire is remains wrapped around the body of the cap. (sorry, its a bit out of focus)

[Image: https://dl.dropboxusercontent.com/u/5462...22_cap.jpg]

This was my first radio restore, so I wasn't restuffing all the caps but I did that one.  I believe however, that the radio will be fine without the wire.  
Cheers,
Bob
[Image: https://www.dropbox.com/s/5m63ib99yfx2eg....jpg?raw=1]
Bob's Restorations Web Page
Website Find
« Next Oldest | Next Newest »


Messages In This Thread
46-421 capacitor - by RF7590 - 02-22-2015, 08:45 PM
RE: 46-421 capacitor - by klondike98 - 02-22-2015, 10:31 PM
RE: 46-421 capacitor - by sam - 02-23-2015, 12:50 PM
RE: 46-421 capacitor - by K7Sparky - 02-24-2015, 01:55 PM
RE: 46-421 capacitor - by klondike98 - 02-24-2015, 11:35 PM
RE: 46-421 capacitor - by sam - 02-25-2015, 05:02 AM
RE: 46-421 capacitor - by Ron Ramirez - 02-25-2015, 08:21 AM
RE: 46-421 capacitor - by K7Sparky - 02-25-2015, 03:21 PM
RE: 46-421 capacitor - by codefox1 - 02-26-2015, 09:58 AM
RE: 46-421 capacitor - by morzh - 02-26-2015, 11:51 AM
RE: 46-421 capacitor - by Chuck Schwark - 02-26-2015, 01:51 PM
RE: 46-421 capacitor - by K7Sparky - 02-27-2015, 02:03 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4819 online users. [Complete List]
» 1 Member(s) | 4818 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration