Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 39-30 Questions
#2

Looking at this chart:


http://www.philcorepairbench.com/lamps.htm

It is a special frosted or painted bulb, but the specs of 6-8 volts at 250 ma also match those of a type 44 which is a bayonet base bulb too, so that should be a good sub. 

I don't see a .02 in the schematic for the ground either, does it look like a factory cap or something someone added later?

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"


Messages In This Thread
Philco 39-30 Questions - by Eric - 03-18-2015, 09:46 AM
RE: Philco 39-30 Questions - by Eliot Ness - 03-18-2015, 10:14 AM
RE: Philco 39-30 Questions - by Eric - 03-18-2015, 10:26 AM
RE: Philco 39-30 Questions - by Eric - 03-18-2015, 10:46 AM
RE: Philco 39-30 Questions - by Eliot Ness - 03-18-2015, 11:03 AM
RE: Philco 39-30 Questions - by Eric - 03-18-2015, 11:23 AM
RE: Philco 39-30 Questions - by Radioroslyn - 03-18-2015, 04:29 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 5795 online users. [Complete List]
» 2 Member(s) | 5793 Guest(s)
AvatarAvatar

>