03-18-2015, 02:04 PM
Got my output xformer and notice that the new one has 490 ohms on the primary and the print shows 700 ohms should I add a 200 ohm resistor?
Philco 40-135 Output Trans Replacement
« Next Oldest | Next Newest »
Messages In This Thread
Philco 40-135 Output Trans Replacement - by Eric - 03-09-2015, 03:43 PM
RE: Philco 40-135 Output Trans Replacement - by codefox1 - 03-09-2015, 05:47 PM
RE: Philco 40-135 Output Trans Replacement - by Eric - 03-09-2015, 08:36 PM
RE: Philco 40-135 Output Trans Replacement - by Eric - 03-18-2015, 02:04 PM
RE: Philco 40-135 Output Trans Replacement - by Radioroslyn - 03-18-2015, 03:14 PM
RE: Philco 40-135 Output Trans Replacement - by Eric - 03-18-2015, 05:24 PM
RE: Philco 40-135 Output Trans Replacement - by Radioroslyn - 03-18-2015, 07:39 PM
RE: Philco 40-135 Output Trans Replacement - by Eric - 03-19-2015, 09:47 AM
Users browsing this thread: 1 Guest(s) |