Gilfillan 5B8

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Gilfillan 5B8

dseverson
Member

Posts: 101
Threads: 11
Joined: Nov 2014
City: Castro Valley, CA

#13

04-01-2015, 02:30 PM

I haven't given up yet on this radio, although I'm about to. I measured the tube pin 3 on 6Q7 and got 78v. I reflowed the solder on the solder lugs but when you say reflow the solder on the pins of 6Q7, are you talking the actual pins on the tube?

As soon as I get something I can use to inject an audio signal, I will try injecting a signal through a .01 cap and ground to pin 5 of 6F6. Don't laugh but would a home made audio signal injector found here work? http://www.instructables.com/id/Tic-Tac-...-Injector/

Dave

Find

« Next Oldest | Next Newest »

Messages In This Thread

Gilfillan 5B8 - by dseverson - 03-26-2015, 02:54 PM

RE: Gilfillan 5B8 - by Radioroslyn - 03-26-2015, 06:21 PM

RE: Gilfillan 5B8 - by dseverson - 03-27-2015, 09:26 PM

RE: Gilfillan 5B8 - by dseverson - 03-27-2015, 09:30 PM

RE: Gilfillan 5B8 - by Radioroslyn - 03-27-2015, 09:48 PM

RE: Gilfillan 5B8 - by dseverson - 03-28-2015, 12:53 AM

RE: Gilfillan 5B8 - by Radioroslyn - 03-28-2015, 07:03 AM

RE: Gilfillan 5B8 - by dseverson - 03-28-2015, 08:49 PM

RE: Gilfillan 5B8 - by Radioroslyn - 03-28-2015, 09:33 PM

RE: Gilfillan 5B8 - by dseverson - 03-30-2015, 12:13 AM

RE: Gilfillan 5B8 - by Radioroslyn - 03-30-2015, 08:39 AM

RE: Gilfillan 5B8 - by dseverson - 03-30-2015, 05:54 PM

RE: Gilfillan 5B8 - by dseverson - 04-01-2015, 02:30 PM

RE: Gilfillan 5B8 - by Radioroslyn - 04-01-2015, 09:32 PM

RE: Gilfillan 5B8 - by dseverson - 04-02-2015, 05:13 PM

RE: Gilfillan 5B8 - by dseverson - 04-03-2015, 09:27 PM

RE: Gilfillan 5B8 - by Radioroslyn - 04-03-2015, 11:12 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 4099 online users. [Complete List]
» 2 Member(s) | 4097 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me