Grandfather Clock Chassis 70 "no volume" Help

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Guest
Unregistered

12-22-2005, 11:00 PM

Hello,
This model 70 early chassis is driving me crazy! I have replaced the capacitors and corrected the hum, now I have no volume or static coming thru the speaker. If I switch the tone control I can hear static in the speaker from the switch, so the speaker is working. Is there a common item I should look for, or can someone direct me to specific areas I should check?
Thank you[/b]

« Next Oldest | Next Newest »

Messages In This Thread

Grandfather Clock Chassis 70 "no volume" Help - by Guest - 12-22-2005, 11:00 PM

[No subject] - by Ron Ramirez - 12-23-2005, 12:03 AM

[No subject] - by Guest - 12-23-2005, 07:07 PM

[No subject] - by Ron Ramirez - 12-24-2005, 01:03 AM

[No subject] - by Terry Judkins - 12-24-2005, 11:18 AM

[No subject] - by Guest - 12-24-2005, 04:00 PM

[No subject] - by Ron Ramirez - 12-24-2005, 04:23 PM

[No subject] - by Guest - 12-24-2005, 04:29 PM

[No subject] - by Chuck Schwark - 12-24-2005, 04:35 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 4297 online users. [Complete List]
» 1 Member(s) | 4296 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me