Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Any IDea what this is???
#9

Well now, here I am. If you're not going to spring for it, somebody is going to nget a mighty fine radio-phono combination.

Yes, there were a lot of them sold, because it was one of the finest radios of the 1929 model year. That's why there are still a few surviving. From the picture, the cabinet looks like it's nice, and here's hopes that it'as nice as it seems to be. These sets were in wide use through WW II, and some time after. When I was in my teens, it was sort of a holy grail to me, and I was in my glory when I finally found one. The audio in them was far ahead of its time.

Like most consoles, it weighs a lot more than a little squawky plastic table (top) radio. The price could go as high as about $150, but anything below that would be a good deal.


Messages In This Thread
Any IDea what this is??? - by jayoungs - 01-14-2009, 05:58 PM
Re: Any IDea what this is??? - by Ron Ramirez - 01-14-2009, 06:31 PM
Re: Any IDea what this is??? - by jayoungs - 01-14-2009, 07:08 PM
Re: Any IDea what this is??? - by jayoungs - 01-14-2009, 07:30 PM
Re: Any IDea what this is??? - by DeckApe - 01-15-2009, 09:18 PM
Re: Any IDea what this is??? - by scooby214 - 01-15-2009, 10:41 PM
Re: Any IDea what this is??? - by Arran - 01-16-2009, 12:11 AM
Re: Any IDea what this is??? - by jayoungs - 01-16-2009, 11:57 AM
Re: Any IDea what this is??? - by Doug Houston - 01-16-2009, 07:27 PM
Re: Any IDea what this is??? - by jayoungs - 01-16-2009, 09:16 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 610B oscillator wiring
Do you know what run # your chassis is? It took me a while to find what you were basing updates/modification on as I did...Radioroslyn — 07:34 AM
Need to purchase some accessories for restoration of my Old Philco Radio
COLLEAGUES, Thank you all for such good and important suggestions as how to find good replacement parts. I will go fo...palonso — 07:05 AM
Zenith H725
Here's what the inside of AM IFT2 looked like, and the other pic shows the discs I made to take place of the mica and ke...EdHolland — 07:40 PM
Zenith H725
IF2 will need replacement caps. The arcing was severe enough that the mica is pitted and holed where the HT flashed over...EdHolland — 04:04 PM
My Philco 37-116 Restore
Measuring from center tap like the tube voltages show. Cap 127 is isolated from ground. Cap 127 shown in upper left of p...dconant — 08:05 AM
My Philco 37-116 Restore
Are you measuring relative to the centertap or the GND?morzh — 11:57 PM
Philco 610B oscillator wiring
Still not clear on the wiring interface between the 6A7 and oscillator. After refering to the available schematics and s...Tubester — 07:18 PM
Refinishing Ideas
My 37-116 code 121 is the best sounding radio i have...a daily driver. Since we are talking about "changes". ...poulsbobill — 07:18 PM
My Philco 37-116 Restore
Hello, I finally got brave enough to take the cans off the Expander Unit. Got the grid cap wires replaced and back toget...dconant — 06:50 PM
Zenith H725
I got into the first AM IF can today, and found its mica was cracked. Amazing that it was still working. This one makes ...EdHolland — 06:10 PM

[-]
Who's Online
There are currently 221 online users. [Complete List]
» 1 Member(s) | 220 Guest(s)
Avatar

>