Philco 42-1012 Power up

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 42-1012 Power up

vecher
Phorum Expert

Posts: 933
Threads: 140
Joined: Mar 2015
City: Lansdale State, Province, Country: PA

#19

04-07-2015, 08:50 PM

ALL ...UPDATE: I just swapped the XXl tube and the 7A4 tube and now radio works. The tubes are supposed to be the same? I get signals on all bands. Weak but I do have them. used sig gen to test the FM band. The calibration on dial is way off too. needs alignment. Next step.

Both tubes tested good on my tube tester.

Only reason I switched was the XXL tube is the RF amp. and the 7A4 tube is use mainly for the phone and driver to the 7c5 output tubes.

Skip...

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 42-1012 Power up - by vecher - 04-04-2015, 10:16 PM

RE: Philco 42-1012 Power up - by morzh - 04-04-2015, 10:38 PM

RE: Philco 42-1012 Power up - by Radioroslyn - 04-04-2015, 10:52 PM

RE: Philco 42-1012 Power up - by morzh - 04-05-2015, 05:21 PM

RE: Philco 42-1012 Power up - by vecher - 04-05-2015, 05:42 PM

RE: Philco 42-1012 Power up - by morzh - 04-05-2015, 06:01 PM

RE: Philco 42-1012 Power up - by vecher - 04-05-2015, 06:31 PM

RE: Philco 42-1012 Power up - by morzh - 04-05-2015, 08:43 PM

RE: Philco 42-1012 Power up - by vecher - 04-05-2015, 09:34 PM

RE: Philco 42-1012 Power up - by Radioroslyn - 04-05-2015, 11:08 PM

RE: Philco 42-1012 Power up - by vecher - 04-06-2015, 02:48 PM

RE: Philco 42-1012 Power up - by morzh - 04-06-2015, 02:56 PM

RE: Philco 42-1012 Power up - by vecher - 04-07-2015, 11:39 AM

RE: Philco 42-1012 Power up - by morzh - 04-07-2015, 12:13 PM

RE: Philco 42-1012 Power up - by vecher - 04-07-2015, 01:31 PM

RE: Philco 42-1012 Power up - by Chuck Schwark - 04-07-2015, 02:08 PM

RE: Philco 42-1012 Power up - by morzh - 04-07-2015, 02:57 PM

RE: Philco 42-1012 Power up - by vecher - 04-07-2015, 03:15 PM

RE: Philco 42-1012 Power up - by vecher - 04-07-2015, 08:50 PM

RE: Philco 42-1012 Power up - by Radioroslyn - 04-07-2015, 09:00 PM

RE: Philco 42-1012 Power up - by vecher - 04-08-2015, 03:14 PM

RE: Philco 42-1012 Power up - by morzh - 04-08-2015, 03:16 PM

RE: Philco 42-1012 Power up - by vecher - 04-11-2015, 02:35 PM

RE: Philco 42-1012 Power up - by morzh - 04-11-2015, 02:46 PM

RE: Philco 42-1012 Power up - by vecher - 04-11-2015, 07:55 PM

RE: Philco 42-1012 Power up - by Radioroslyn - 04-11-2015, 08:31 PM

RE: Philco 42-1012 Power up - by vecher - 04-12-2015, 10:13 PM

RE: Philco 42-1012 Power up - by morzh - 04-13-2015, 12:06 AM

View a Printable Version

Users browsing this thread: 6 Guest(s)

Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

Who's Online

There are currently 5691 online users. [Complete List]
» 1 Member(s) | 5690 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me