Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Radio Speaker Model 531
#1

Hello everyone. I have a working Philco Radio Speaker Model 531 in very good condition. I have read a lot of posts but still have not found the correct place to sell the radio and have no idea what would be a fair asking price. Please help. I do not want to try to sell it to high but I also do not want to get ripped off. I am sorry if I had posted this thread in the wrong spot. I do not know anything about antique radios. My father in law used to listen to this radio with his family when he was a little kid. His father bought the radio new and it has been in the attic for a long time. It has a few scratches and a little scuff mark on top. And from what I have researched, it does not have the back panel. It works great. I just plugged it in and listened to it for a little while. It is amazing that a radio so old still works. Even used the fine tuning knob to listen to a local broadcast. Any advice would be well appreciated. Thank you.


Messages In This Thread
Philco Radio Speaker Model 531 - by ptomt77 - 04-12-2015, 11:42 PM
RE: Philco Radio Speaker Model 531 - by ptomt77 - 04-13-2015, 09:35 AM
RE: Philco Radio Speaker Model 531 - by ptomt77 - 04-13-2015, 09:43 AM
RE: Philco Radio Speaker Model 531 - by ptomt77 - 04-13-2015, 09:47 AM
RE: Philco Radio Speaker Model 531 - by ptomt77 - 04-13-2015, 08:21 PM
RE: Philco Radio Speaker Model 531 - by ptomt77 - 04-13-2015, 08:39 PM



Users browsing this thread: 12 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Well, a wave trap is a trimmer in series with the coil so at the resonant frequency it provides a short to ground. This ...RodB — 10:07 AM
Philco 60 Squealing
Rod, My radio is run 7. The wave trap is on that schematic as shown in the picture. dconant — 09:21 AM
American Bosch Model 802 auto radio
Hi Arran ,  Thanks for your help with this radio.And especial thanks for letting me know to look it up under United Ame...Antipodal — 04:32 AM
Philco 60 Squealing
Usually a wave trap is for keeping IF signals from entering the antenna and from leaving the antenna. You feed an IF sig...RodB — 09:30 PM
Philco 60 Squealing
I just peaked it for the best signal at 600. NULL it for IF frequency, originally it would have been null for 500kh...Chas — 08:05 PM
Philco 60 Squealing
Wavetrap no longer matters.morzh — 05:19 PM
Philco 60 Squealing
Rod, I had checked out your suggestions but did not help. I did solder the ground rivets to the chassis as Chas suggeste...dconant — 04:52 PM
37-690 Bass Choke Replacement
Yeah, I know, Mouser and Digikey don't have "big iron" components. For some reason Philco was messing with the...Radiodial — 04:25 PM
37-690 Bass Choke Replacement
Yes, I just had to deal with that while repairing the 37-604 Philco. Exactly that value choke was gone. And the current ...morzh — 03:52 PM
37-690 Bass Choke Replacement
Ah, now where to find one. I've into this before on smaller sets, I now recall. Hammond makes one that is only rated...Radiodial — 03:27 PM

[-]
Who's Online
There are currently 3664 online users. [Complete List]
» 2 Member(s) | 3662 Guest(s)
AvatarAvatar

>