Bakelite block challenge???

Register

Guest Join Us

Hello Guest,

Please feel free to join us!
There are many more parts of the Phorum that only members can see.

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Bakelite block challenge???

Dan Walker
Senior Member

Posts: 371
Threads: 103
Joined: Jul 2011
City: Calgary, AB, CA

#5

04-21-2015, 08:44 PM

   Thanks for that information, it is very helpful.
   I still have a question about the value of the cap in question.. on the schematic it is #80 which says it is a .03 uF.
   Maybe I am looking at the wrong block, but in tracking the wires   from the heater of the rectifier tube I get them going to a .o3 cap , #80 [ on the schematic] but in that block it tells me that there are .05 caps in there.
    I feel that I am missing something here.

Living in Calgary Alberta

Find

« Next Oldest | Next Newest »

Messages In This Thread

Bakelite block challenge??? - by Dan Walker - 04-21-2015, 05:07 PM

RE: Bakelite block challenge??? - by radiohenry - 04-21-2015, 07:12 PM

RE: Bakelite block challenge??? - by sam - 04-21-2015, 07:16 PM

RE: Bakelite block challenge??? - by klondike98 - 04-21-2015, 07:24 PM

RE: Bakelite block challenge??? - by Dan Walker - 04-21-2015, 08:44 PM

RE: Bakelite block challenge??? - by klondike98 - 04-21-2015, 09:21 PM

RE: Bakelite block challenge??? - by Dan Walker - 04-23-2015, 09:45 AM

RE: Bakelite block challenge??? - by morzh - 04-23-2015, 10:52 AM

RE: Bakelite block challenge??? - by klondike98 - 04-23-2015, 12:29 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM

Who's Online

There are currently 1698 online users. [Complete List]
» 2 Member(s) | 1696 Guest(s)