Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Strange Philco player attachment
#1

Almost forgot about it, but I've had an interesting phonograph attachment in the collection for a few years. It has the conventional turntable, but the pickup head is on a sliding rod in the lid of the case. When the lid is opened, it slides down to the start position for playing. Close the lid and the pickup contacts the record and plays it. The travel of the pickup across the record is purely linear, so there is no tracking error. I remember seeing something on this in an article somewhere, but I can't find a model number on it, so I've turned to Ron R. and quizzed him about it.

In playing a record, you have to play the disc from the beginning. You can't cue in along the playing surface. If you lift the lid, you start over again. It might be correct to say that it's TOO automatic! There also is no provision for playing a 12 inch record.


Messages In This Thread
Strange Philco player attachment - by Doug Houston - 12-24-2005, 12:19 AM
[No subject] - by Ron Ramirez - 12-24-2005, 10:32 AM
[No subject] - by panther - 01-26-2006, 10:31 PM
[No subject] - by Ron Ramirez - 01-26-2006, 10:43 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM

[-]
Who's Online
There are currently 3228 online users. [Complete List]
» 4 Member(s) | 3224 Guest(s)
AvatarAvatarAvatarAvatar

>