1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 45C filter choke
morzh
Odobenus rosmarus
******
Posts: 16,476
Threads: 573
Joined: Oct 2011
City: Jackson State, Province, Country: NJ
#3

04-24-2015, 11:49 AM
Exact same as in 66, same arrangement too. Yes 10mA. According to what I remember when I calculated the current, it was a bit marginal, and since his is not the first choke I see burnt in this same place I think Philco cut corners on this one a bit rating it marginally.
Now a typical output transformer will likely be rated a bit better current-wise but then it can have lower inductance and surely lower DC resistance. DC resistance is not as important as it is still small compared to the resistors in series with it.
It might work just fine. Especially considering a 6uF cap after it.
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Philco 45C filter choke - by jmac3ky - 04-24-2015, 11:28 AM
RE: Philco 45C filter choke - by Ron Ramirez - 04-24-2015, 11:36 AM
RE: Philco 45C filter choke - by jmac3ky - 04-24-2015, 12:44 PM
RE: Philco 45C filter choke - by morzh - 04-24-2015, 11:49 AM
RE: Philco 45C filter choke - by Mondial - 04-24-2015, 01:35 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Need to purchase some accessories for restoration of my Old Philco Radio
Hi Paulo, Welcome to the Philco Phorum. I can see why you want to find good reproduction parts. That is a bea...MrFixr55 — 11:10 PM
HiFi (Chifi) tube amp build - but my own design.
Tim, I have some bakelite sockets in my work shop that I can dig up. I believe quite a few are NOS. I will take photo...RodB — 10:03 PM
Philco 610B oscillator wiring
> The cathode as noted is wired directly to the ground side of the heater filament for that tube, not to the #17 and ...Radioroslyn — 08:12 PM
HiFi (Chifi) tube amp build - but my own design.
Tim; I noticed your post a little late, but I would take one of the junk sockets and try to break a chunk out of it wi...Arran — 08:07 PM
Need to purchase some accessories for restoration of my Old Philco Radio
Here is a list of resources found in our online library that you might find useful. Mike's Gobs of Knobs email addres...klondike98 — 01:46 PM
First Radio restoration
Hi Tubeman, Welcome to the Philco Phorum.  Phamily Phriendly Pfun with Phine Pholks Phull of Philco Phacts. (See a p...MrFixr55 — 12:33 PM
First Radio restoration
You could post in the WANTED ADs section here on the Phorum and see if anyone has an RF generator that they want to sell...klondike98 — 11:55 AM
Zenith H725
Good ideas, thank you Arrange and Rich. I have the adhesive aluminum foil already and can try that immediately. More ...EdHolland — 10:18 AM
Graphics for majestic 1050 dial glass.
Murf; I found this thread on the ARF, the first photo has a pretty good view of the dial glass. Regards ArranArran — 01:12 AM
Zenith H725
hello Ed, how about that speacial tape used for ducting it's like foil or how about thin piece of aluminum roof flash...radiorich — 12:19 AM

[-]
Who's Online
There are currently 1388 online users. [Complete List]
» 1 Member(s) | 1387 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration