1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
635 Tombstone
Warren
Senior Member
****
Posts: 736
Threads: 26
Joined: Jun 2013
City: Hayward, California
#10

04-25-2015, 12:52 AM
(04-23-2015, 11:22 PM)Steve Davis Wrote:  Yes, the clip is sandwiched between cardboard insulator and the shell of the capacitor to connect the shell to B- .

Steve

Thank you very much Steve, it is a little confusing following the wire , doesn't seem to go to transformer.. im sure it does then, obviously just a different route. Hope I get better at tracing some of these wires, most are pretty obvious but looks like others give me trouble so far. I appreciate it.
Find
« Next Oldest | Next Newest »


Messages In This Thread
635 Tombstone - by Warren - 04-12-2015, 06:49 PM
RE: 635 Tombstone - by klondike98 - 04-12-2015, 07:06 PM
RE: 635 Tombstone - by Warren - 04-12-2015, 10:02 PM
RE: 635 Tombstone - by Warren - 04-20-2015, 02:19 AM
RE: 635 Tombstone - by Ron Ramirez - 04-20-2015, 07:11 AM
RE: 635 Tombstone - by Warren - 04-20-2015, 04:09 PM
RE: 635 Tombstone - by Warren - 04-22-2015, 11:41 PM
RE: 635 Tombstone - by Warren - 04-23-2015, 11:12 PM
RE: 635 Tombstone - by Steve Davis - 04-23-2015, 11:22 PM
RE: 635 Tombstone - by Warren - 04-25-2015, 12:52 AM



Users browsing this thread: 8 Guest(s)
[-]
Recent Posts
Made mistake & did not label connection
Happy Thanksgiving all! I have made a real bonehead mistake this time. Hope someone can help.  I am trying to determi...georgetownjohn — 12:51 PM
New Philco Repair Bench
Apparently there is a new Philco Repair Bench found at https://philcoradio.com/repairbench/ When I try to go to order a ...dconant — 12:00 PM
Philco 60 Squealing
Well, a wave trap is a trimmer in series with the coil so at the resonant frequency it provides a short to ground. This ...RodB — 10:07 AM
Philco 60 Squealing
Rod, My radio is run 7. The wave trap is on that schematic as shown in the picture. dconant — 09:21 AM
American Bosch Model 802 auto radio
Hi Arran ,  Thanks for your help with this radio.And especial thanks for letting me know to look it up under United Ame...Antipodal — 04:32 AM
Philco 60 Squealing
Usually a wave trap is for keeping IF signals from entering the antenna and from leaving the antenna. You feed an IF sig...RodB — 09:30 PM
Philco 60 Squealing
I just peaked it for the best signal at 600. NULL it for IF frequency, originally it would have been null for 500kh...Chas — 08:05 PM
Philco 60 Squealing
Wavetrap no longer matters.morzh — 05:19 PM
Philco 60 Squealing
Rod, I had checked out your suggestions but did not help. I did solder the ground rivets to the chassis as Chas suggeste...dconant — 04:52 PM
37-690 Bass Choke Replacement
Yeah, I know, Mouser and Digikey don't have "big iron" components. For some reason Philco was messing with the...Radiodial — 04:25 PM

[-]
Who's Online
There are currently 6538 online users. [Complete List]
» 2 Member(s) | 6536 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration