1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 38-62 from the AHRS swap meet
TheUniversalDave1
Member
***
Posts: 142
Threads: 22
Joined: Mar 2015
City: Gardendale, AL
#8

04-29-2015, 10:29 PM
    This Saturday, I will be restuphing the philter can and replacing all the wax paper caps NOT in the bakelite blocks. Those will come at a later date, as I only have 2-3 hours to work on Saturday morning. If somebody could post a picture of their 38-62 chassis underside, I would greatly appreciate it.

Is this drawing I made of the philter can correct? 
Slave to an RCA Victor CTC-25
(This post was last modified: 04-29-2015, 11:22 PM by TheUniversalDave1.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: Philco 38-62 from the AHRS swap meet - by sam - 04-25-2015, 12:57 PM
RE: Philco 38-62 from the AHRS swap meet - by TheUniversalDave1 - 04-29-2015, 10:29 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Well, a wave trap is a trimmer in series with the coil so at the resonant frequency it provides a short to ground. This ...RodB — 10:07 AM
Philco 60 Squealing
Rod, My radio is run 7. The wave trap is on that schematic as shown in the picture. dconant — 09:21 AM
American Bosch Model 802 auto radio
Hi Arran ,  Thanks for your help with this radio.And especial thanks for letting me know to look it up under United Ame...Antipodal — 04:32 AM
Philco 60 Squealing
Usually a wave trap is for keeping IF signals from entering the antenna and from leaving the antenna. You feed an IF sig...RodB — 09:30 PM
Philco 60 Squealing
I just peaked it for the best signal at 600. NULL it for IF frequency, originally it would have been null for 500kh...Chas — 08:05 PM
Philco 60 Squealing
Wavetrap no longer matters.morzh — 05:19 PM
Philco 60 Squealing
Rod, I had checked out your suggestions but did not help. I did solder the ground rivets to the chassis as Chas suggeste...dconant — 04:52 PM
37-690 Bass Choke Replacement
Yeah, I know, Mouser and Digikey don't have "big iron" components. For some reason Philco was messing with the...Radiodial — 04:25 PM
37-690 Bass Choke Replacement
Yes, I just had to deal with that while repairing the 37-604 Philco. Exactly that value choke was gone. And the current ...morzh — 03:52 PM
37-690 Bass Choke Replacement
Ah, now where to find one. I've into this before on smaller sets, I now recall. Hammond makes one that is only rated...Radiodial — 03:27 PM

[-]
Who's Online
There are currently 2001 online users. [Complete List]
» 3 Member(s) | 1998 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration