1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
42-1008P ALigntment
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#14

05-20-2015, 09:59 PM
That is pretty good, actually. You may not get any better than that.
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »


Messages In This Thread
42-1008P ALigntment - by Edisla - 05-10-2015, 11:58 PM
RE: 42-1008P ALigntment - by Warren - 05-11-2015, 12:07 AM
RE: 42-1008P ALigntment - by vecher - 05-11-2015, 09:54 AM
RE: 42-1008P ALigntment - by Edisla - 05-11-2015, 10:43 AM
RE: 42-1008P ALigntment - by vecher - 05-11-2015, 11:29 AM
RE: 42-1008P ALigntment - by Edisla - 05-11-2015, 01:25 PM
RE: 42-1008P ALigntment - by Edisla - 05-11-2015, 09:56 PM
RE: 42-1008P ALigntment - by vecher - 05-11-2015, 11:31 PM
RE: 42-1008P ALigntment - by Edisla - 05-11-2015, 11:57 PM
RE: 42-1008P ALigntment - by Edisla - 05-12-2015, 12:48 AM
RE: 42-1008P ALigntment - by Nick3092 - 05-12-2015, 10:09 AM
RE: 42-1008P ALigntment - by vecher - 05-18-2015, 11:36 PM
RE: 42-1008P ALigntment - by Edisla - 05-20-2015, 09:48 PM
RE: 42-1008P ALigntment - by Ron Ramirez - 05-20-2015, 09:59 PM
RE: 42-1008P ALigntment - by Edisla - 05-20-2015, 10:23 PM
RE: 42-1008P ALigntment - by vecher - 05-20-2015, 10:32 PM
RE: 42-1008P ALigntment - by Edisla - 05-21-2015, 11:41 AM
RE: 42-1008P ALigntment - by vecher - 05-21-2015, 09:18 PM



Users browsing this thread: 11 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration