1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Hallicrafters S-38E- Alignment
vecher
Phorum Expert
*****
Posts: 933
Threads: 140
Joined: Mar 2015
City: Lansdale State, Province, Country: PA
#7

06-06-2015, 11:15 PM
Ok started alignment.. No Go..Radio will not align on any of the bands. It will receive on all bands. But lets say on band 1 The AM band.. Started to align at 1500 Kc however the 1500 KC signal was no where to be found so I changed to 1000 KC it appeared at around 1300 Kc so tried to adjust trimmers and was able to move it a little to around 1200 Kc then I ran out of adjustment as the trimmer was fully open... This happens on all bands. What could cause all bands to not align??

Skip...
Find
« Next Oldest | Next Newest »


Messages In This Thread
Hallicrafters S-38E- Alignment - by vecher - 06-05-2015, 11:27 PM
RE: Hallicrafters S-38E- Alignment - by codefox1 - 06-06-2015, 01:32 PM
RE: Hallicrafters S-38E- Alignment - by vecher - 06-06-2015, 02:25 PM
RE: Hallicrafters S-38E- Alignment - by David - 06-06-2015, 04:12 PM
RE: Hallicrafters S-38E- Alignment - by David - 06-06-2015, 04:17 PM
RE: Hallicrafters S-38E- Alignment - by vecher - 06-06-2015, 06:13 PM
RE: Hallicrafters S-38E- Alignment - by vecher - 06-06-2015, 11:15 PM
RE: Hallicrafters S-38E- Alignment - by David - 06-07-2015, 12:35 PM
RE: Hallicrafters S-38E- Alignment - by David - 06-07-2015, 12:44 PM
RE: Hallicrafters S-38E- Alignment - by vecher - 06-07-2015, 03:53 PM
RE: Hallicrafters S-38E- Alignment - by vecher - 06-07-2015, 07:50 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 4949 online users. [Complete List]
» 3 Member(s) | 4946 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)