Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

49-1600 console serial 95414
#4

What's it's worth???
That's a good question. Generally speaking it's not quite old enough to be really collectable. Seems like post war sets don't bring much unless they have an unusual design. Consoles are getting hard to get rid of unless they have a lot of knobs and a high tube count.
The chassis on that set is pretty pedestrian. Typical "AC-DC" set with a voltage doubler power supply. Will only work on AC because of the phono motor and the voltage doubler.
Personally I would not mess with it there too many better sets to waste time on. With that being said I would guess at somewhere around $25-50.
Sorry to be so brutal!

Terry


Messages In This Thread
49-1600 console serial 95414 - by brownie45 - 06-11-2015, 08:34 AM
RE: 49-1600 console serial 95414 - by sam - 06-11-2015, 11:43 AM
RE: 49-1600 console serial 95414 - by brownie45 - 06-11-2015, 12:59 PM
RE: 49-1600 console serial 95414 - by Radioroslyn - 06-11-2015, 09:35 PM
RE: 49-1600 console serial 95414 - by morzh - 06-11-2015, 10:12 PM
RE: 49-1600 console serial 95414 - by Arran - 06-11-2015, 11:36 PM
RE: 49-1600 console serial 95414 - by brownie45 - 06-12-2015, 08:10 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 6153 online users. [Complete List]
» 2 Member(s) | 6151 Guest(s)
AvatarAvatar

>