Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Delco Model 60108
#11

(06-16-2015, 02:10 PM)Warren Wrote:  
(06-16-2015, 10:31 AM)Phlogiston Wrote:  Look for the schematic on Nostalgia Air under United Moters Service - Delco.

http://www.nostalgiaair.org/Resources/

Are you sure of that model number?

Before and after refinishing picture of mine:



I added the shading to match the original finish.

OK, I will look on nostalgiair. No, not 100% sure of the model number, that is what someone wrote on the back of the radio. Your radio looks real nice. I thought mine was the original finish, doesnt look like anyone has done anything to the cabinet, but like i say the edges arent really darker than the front like yours. Looks nice with the darker edges.

It might be the original finish. They weren't necessarily all the same or finished at the same time by the same guys.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/


Messages In This Thread
Delco Model 60108 - by Warren - 06-14-2015, 11:39 PM
RE: Delco Model 60108 - by Radioroslyn - 06-15-2015, 07:47 AM
RE: Delco Model 60108 - by sam - 06-15-2015, 12:05 PM
RE: Delco Model 60108 - by morzh - 06-15-2015, 12:07 PM
RE: Delco Model 60108 - by Warren - 06-15-2015, 12:58 PM
RE: Delco Model 60108 - by Phlogiston - 06-15-2015, 01:18 PM
RE: Delco Model 60108 - by Warren - 06-15-2015, 02:16 PM
RE: Delco Model 60108 - by Phlogiston - 06-16-2015, 10:31 AM
RE: Delco Model 60108 - by Warren - 06-16-2015, 02:10 PM
RE: Delco Model 60108 - by Phlogiston - 06-17-2015, 12:06 AM
RE: Delco Model 60108 - by TimC - 06-16-2015, 09:53 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 5593 online users. [Complete List]
» 2 Member(s) | 5591 Guest(s)
AvatarAvatar

>