Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Scored a 41-280x this morning!
#8

OK guys, time to start picking your brains.  In anticipation of having to replace all the wiring in the chassis for it's crumbling insulation I need to get a supply of new wire.  Any suggestions of what gauge wire I should buy?  Also, should I go with solid wire or multi-strand?  A question also about the tubes in the chassis.  Are the XXL tubes interchangeable with 7A4 tubes?  Remember, I'm not the electronic wizards you folks are.  Learning as I go.  Thanks for all the help. Take care, Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan


Messages In This Thread
Scored a 41-280x this morning! - by GarySP - 06-13-2015, 05:11 PM
RE: Scored a 41-280x this morning! - by morzh - 06-13-2015, 06:56 PM
RE: Scored a 41-280x this morning! - by TA Forbes - 06-14-2015, 09:48 PM
RE: Scored a 41-280x this morning! - by GarySP - 06-14-2015, 10:16 PM
RE: Scored a 41-280x this morning! - by Arran - 06-15-2015, 01:02 AM
RE: Scored a 41-280x this morning! - by GarySP - 06-16-2015, 08:58 AM
RE: Scored a 41-280x this morning! - by Art Hoch - 06-19-2015, 09:49 PM
RE: Scored a 41-280x this morning! - by GarySP - 06-17-2015, 11:40 AM
RE: Scored a 41-280x this morning! - by morzh - 06-17-2015, 12:15 PM
RE: Scored a 41-280x this morning! - by GarySP - 06-18-2015, 01:11 PM
RE: Scored a 41-280x this morning! - by morzh - 06-18-2015, 06:24 PM
RE: Scored a 41-280x this morning! - by morzh - 06-18-2015, 08:53 PM
RE: Scored a 41-280x this morning! - by morzh - 06-19-2015, 10:42 AM
RE: Scored a 41-280x this morning! - by GarySP - 06-18-2015, 09:25 PM
RE: Scored a 41-280x this morning! - by Arran - 06-19-2015, 04:27 AM
RE: Scored a 41-280x this morning! - by GarySP - 06-20-2015, 04:17 PM
RE: Scored a 41-280x this morning! - by GarySP - 06-20-2015, 07:26 PM
RE: Scored a 41-280x this morning! - by Art Hoch - 06-20-2015, 09:30 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM
HiFi (Chifi) tube amp build - but my own design.
Tim Well...a chassis is metal. Magnetic or not, it does not matter. A transformer has some hum to it. It is natural. Th...morzh — 08:40 PM
Hickok AC51 tube tester
I thought the 83 tube was bad because it looked white but it tests strong. Blue gassy though. I checked the fuse, it was...martinj — 08:37 PM

[-]
Who's Online
There are currently 3075 online users. [Complete List]
» 1 Member(s) | 3074 Guest(s)
Avatar

>