Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-623 BOL
#5

hey greg
so your getting almost 5 volts to light  but it works with 6volt battery
you need to see why your not getting 6volts #66 adjustable resister good ?
sounds like your not getting correct voltage
and they are special bulbs I think
they are hard as H**l some times to get out little heat maybe
sam
 

Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2


Messages In This Thread
41-623 BOL - by NostalgiaRadioTime - 06-17-2015, 09:13 PM
RE: 41-623 BOL - by sam - 06-18-2015, 12:07 PM
RE: 41-623 BOL - by NostalgiaRadioTime - 06-18-2015, 06:50 PM
RE: 41-623 BOL - by NostalgiaRadioTime - 06-18-2015, 08:39 PM
RE: 41-623 BOL - by sam - 06-19-2015, 03:12 AM
RE: 41-623 BOL - by sam - 06-23-2015, 12:30 PM
RE: 41-623 BOL - by marv - 06-24-2015, 07:57 PM
RE: 41-623 BOL - by NostalgiaRadioTime - 06-24-2015, 10:01 PM
RE: 41-623 BOL - by sam - 06-25-2015, 03:37 AM
RE: 41-623 BOL - by NostalgiaRadioTime - 06-29-2015, 07:33 PM
RE: 41-623 BOL - by sam - 06-30-2015, 03:12 AM
RE: 41-623 BOL - by NostalgiaRadioTime - 06-30-2015, 09:39 PM
RE: 41-623 BOL - by sam - 06-30-2015, 10:48 PM
RE: 41-623 BOL - by sam - 08-30-2015, 09:29 PM
RE: 41-623 BOL - by NostalgiaRadioTime - 08-30-2015, 09:50 PM
RE: 41-623 BOL - by Crist Rigotti - 08-30-2015, 10:07 PM
RE: 41-623 BOL - by sam - 08-30-2015, 10:22 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT-6 antenna connections
Hi Bridcarl +1 on the others.  Pin 6 of the 7C6 is the AVC Diode so it is appropriate that that pin 4 of the coil con...MrFixr55 — 07:30 AM
462ron
Joseph, this is beyond awesome. A lot of thought and engineering went into this and you hit a home run! Now I must save ...462ron — 07:27 AM
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM

[-]
Who's Online
There are currently 3284 online users. [Complete List]
» 2 Member(s) | 3282 Guest(s)
AvatarAvatar

>