Scored a 41-280x this morning!

Thread Rating:

GarySP
Super Moderator

Posts: 1,975
Threads: 147
Joined: Jan 2013
City: Westland, MI

#21

06-20-2015, 07:26 PM

OK everyone. With the help of my son I've got a few photos to post! ( I am terrible with computers. Actually, still rotary phone friendly.)

[Image: http://i12.photobucket.com/albums/a242/G...mkgkum.jpg]

[Image: http://i12.photobucket.com/albums/a242/G...vrezw8.jpg]

[Image: http://i12.photobucket.com/albums/a242/G...0ajqc1.jpg]

[Image: http://i12.photobucket.com/albums/a242/G...f6xnx7.jpg]

[Image: http://i12.photobucket.com/albums/a242/G...lth0dn.jpg]

[Image: http://i12.photobucket.com/albums/a242/G...2m1nkl.jpg]

I took the speaker out. It was only held in by two out of six screws. The last photo of the left side of the cabinet is where I have already carved and glued in a piece of veneer at the back that was broken off. Still have to grain fill and blend it in. As I said earlier, not an original cabinet finish, but not unappealing either. Should look presentable with a little attention. Take care, Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan

Find

« Next Oldest | Next Newest »

Messages In This Thread

RE: Scored a 41-280x this morning! - by GarySP - 06-20-2015, 07:26 PM

Users browsing this thread: 15 Guest(s)

Recent Posts
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit. That would rem...alangard — 09:30 PM
HiFi (Chifi) tube amp build - but my own design.
Tim Well...a chassis is metal. Magnetic or not, it does not matter. A transformer has some hum to it. It is natural. Th...morzh — 08:40 PM
Hickok AC51 tube tester
I thought the 83 tube was bad because it looked white but it tests strong. Blue gassy though. I checked the fuse, it was...martinj — 08:37 PM

Who's Online

There are currently 5807 online users. [Complete List]
» 1 Member(s) | 5806 Guest(s)