Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Radio Bar on American Pickers
#13

I think the main reason I still watch is because they used a photo of me from 1965 in one of the shows:I'm the 2nd on the right

Eric
The Villages, FL
Member: Philco Phorum, ARF, ARCI & Radiomuseum.org



Messages In This Thread
Radio Bar on American Pickers - by Eric Adams - 06-17-2015, 10:41 PM
RE: Radio Bar on American Pickers - by morzh - 06-18-2015, 09:43 AM
RE: Radio Bar on American Pickers - by Warren - 06-18-2015, 12:59 PM
RE: Radio Bar on American Pickers - by TA Forbes - 06-18-2015, 01:01 PM
RE: Radio Bar on American Pickers - by Arran - 06-19-2015, 03:43 AM
RE: Radio Bar on American Pickers - by Warren - 06-18-2015, 01:03 PM
RE: Radio Bar on American Pickers - by morzh - 06-18-2015, 06:21 PM
RE: Radio Bar on American Pickers - by sdradioman - 06-21-2015, 10:53 PM
RE: Radio Bar on American Pickers - by morzh - 06-21-2015, 10:58 PM
RE: Radio Bar on American Pickers - by Eric Adams - 06-21-2015, 11:11 PM



Users browsing this thread: 7 Guest(s)
[-]
Recent Posts
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM

[-]
Who's Online
There are currently 7864 online users. [Complete List]
» 1 Member(s) | 7863 Guest(s)
Avatar

>