Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-116 shipping questions.
#2

I shipped a 38-116 (which is the same as the shipping goes) to Ukraine before. By the sea. In any case, the packaging had to be adequate.

If you pack it yourself, you can save about $100. The chassis is best shipped separately, although Greyhound could be OK to ship as a whole.
I would say, probably Greyhound. The price will likely depend on the distance, Willie Z ships this size radios by it for $80 to $100.

Your best bet is to weigh, measure, call Greyhound and ask them what they think it would be.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.


Messages In This Thread
Philco 38-116 shipping questions. - by louxwe - 06-24-2015, 11:14 AM
RE: Philco 38-116 shipping questions. - by morzh - 06-24-2015, 11:28 AM
RE: Philco 38-116 shipping questions. - by Arran - 06-25-2015, 11:50 PM
RE: Philco 38-116 shipping questions. - by morzh - 06-26-2015, 02:10 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6896 online users. [Complete List]
» 1 Member(s) | 6895 Guest(s)
Avatar

>