A PITA recap job

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

A PITA recap job

Radioroslyn
Phorum Expert

Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

06-29-2015, 04:37 PM

Where do you find these things with goofy p/s????
Half the p/s powers the radio and the other powers the field coil in the spkr.

Connect - leads from a 4mf and a 12mf. Connect that to the off/on switch, the side that doesn't have the line cord connected to it.

Connect the + 4mf to pin 3 of the 25Z5.

Connect the +12mf to pin 4 of the 25Z5 also connect the + of the second 4mf cap here too.

Connect the - of the second 4mf to L-9 the side that isn't connected the the off/on switch.
EASY!!!!!

Terry
ps How's the line cord?? Methinks it is a resistance cord w/a 150ohm wound up in it.

(This post was last modified: 06-29-2015, 04:46 PM by Radioroslyn.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

A PITA recap job - by OldRestorer - 06-29-2015, 03:26 PM

RE: A PITA recap job - by morzh - 06-29-2015, 04:10 PM

RE: A PITA recap job - by OldRestorer - 06-29-2015, 04:12 PM

RE: A PITA recap job - by morzh - 06-29-2015, 04:13 PM

RE: A PITA recap job - by Radioroslyn - 06-29-2015, 04:37 PM

RE: A PITA recap job - by morzh - 06-29-2015, 04:53 PM

RE: A PITA recap job - by OldRestorer - 06-30-2015, 11:07 AM

RE: A PITA recap job - by Radioroslyn - 06-30-2015, 02:52 PM

RE: A PITA recap job - by OldRestorer - 06-30-2015, 06:46 PM

RE: A PITA recap job - by Radioroslyn - 06-30-2015, 07:18 PM

RE: A PITA recap job - by Arran - 07-01-2015, 04:30 AM

RE: A PITA recap job - by morzh - 07-01-2015, 09:35 AM

RE: A PITA recap job - by OldRestorer - 07-01-2015, 09:59 AM

RE: A PITA recap job - by OldRestorer - 07-01-2015, 10:31 AM

RE: A PITA recap job - by sam - 07-01-2015, 12:10 PM

RE: A PITA recap job - by morzh - 07-01-2015, 01:19 PM

RE: A PITA recap job - by Radioroslyn - 07-01-2015, 04:46 PM

RE: A PITA recap job - by morzh - 07-01-2015, 04:47 PM

RE: A PITA recap job - by OldRestorer - 07-01-2015, 06:14 PM

RE: A PITA recap job - by OldRestorer - 07-01-2015, 09:09 PM

RE: A PITA recap job - by sam - 07-01-2015, 10:50 PM

RE: A PITA recap job - by OldRestorer - 07-02-2015, 08:55 AM

RE: A PITA recap job - by morzh - 07-02-2015, 09:10 AM

RE: A PITA recap job - by sam - 07-02-2015, 12:23 PM

RE: A PITA recap job - by OldRestorer - 07-02-2015, 03:55 PM

RE: A PITA recap job - by Radioroslyn - 07-05-2015, 09:53 PM

RE: A PITA recap job - by sam - 07-05-2015, 10:30 PM

RE: A PITA recap job - by morzh - 07-06-2015, 10:09 AM

RE: A PITA recap job - by sam - 07-06-2015, 11:45 AM

RE: A PITA recap job - by Radioroslyn - 07-06-2015, 12:41 PM

RE: A PITA recap job - by sam - 07-06-2015, 12:50 PM

RE: A PITA recap job - by morzh - 07-06-2015, 01:19 PM

RE: A PITA recap job - by Radioroslyn - 07-06-2015, 04:54 PM

RE: A PITA recap job - by morzh - 07-06-2015, 07:06 PM

View a Printable Version

Users browsing this thread: 5 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me