Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

A PITA recap job
#11

No Kirk;
  In this case you are not the dumb one, whomever designed this thing was the dumb one, or crazy. At first glance I thought that maybe they had used the 25Z5 for a voltage doubler, but no, one diode does absolutely nothing but power the field coil for the speaker. In most of these early AC/DC sets they connected both of the diodes in the 25Z5/25Z6s together in parallel.
 Now you would think, hmm, AC/DC set, department store set, so cheap set, but these clowns added an extra filter choke doing what could be done with the field coil on the speaker. I can only speculate as to why they did this? A trainload of speakers for DC only sets that had no hum bucker? A rail car full of filter chokes they had to use up? Patent royalty circumvention?
 In any event filter cap C20A and C20B and paper cap C19, one end of the speaker field coil, and one end of that filter choke are all connected to the same place electrically, to the switched side of the power line which is B-. Capacitor C20C is connected to the other end of that filter choke, which is connected to the common negative for the rest of the set.
Regards
Arran


Messages In This Thread
A PITA recap job - by OldRestorer - 06-29-2015, 03:26 PM
RE: A PITA recap job - by morzh - 06-29-2015, 04:10 PM
RE: A PITA recap job - by OldRestorer - 06-29-2015, 04:12 PM
RE: A PITA recap job - by morzh - 06-29-2015, 04:13 PM
RE: A PITA recap job - by Radioroslyn - 06-29-2015, 04:37 PM
RE: A PITA recap job - by morzh - 06-29-2015, 04:53 PM
RE: A PITA recap job - by OldRestorer - 06-30-2015, 11:07 AM
RE: A PITA recap job - by Radioroslyn - 06-30-2015, 02:52 PM
RE: A PITA recap job - by OldRestorer - 06-30-2015, 06:46 PM
RE: A PITA recap job - by Radioroslyn - 06-30-2015, 07:18 PM
RE: A PITA recap job - by Arran - 07-01-2015, 04:30 AM
RE: A PITA recap job - by morzh - 07-01-2015, 09:35 AM
RE: A PITA recap job - by OldRestorer - 07-01-2015, 09:59 AM
RE: A PITA recap job - by OldRestorer - 07-01-2015, 10:31 AM
RE: A PITA recap job - by sam - 07-01-2015, 12:10 PM
RE: A PITA recap job - by morzh - 07-01-2015, 01:19 PM
RE: A PITA recap job - by Radioroslyn - 07-01-2015, 04:46 PM
RE: A PITA recap job - by morzh - 07-01-2015, 04:47 PM
RE: A PITA recap job - by OldRestorer - 07-01-2015, 06:14 PM
RE: A PITA recap job - by OldRestorer - 07-01-2015, 09:09 PM
RE: A PITA recap job - by sam - 07-01-2015, 10:50 PM
RE: A PITA recap job - by OldRestorer - 07-02-2015, 08:55 AM
RE: A PITA recap job - by morzh - 07-02-2015, 09:10 AM
RE: A PITA recap job - by sam - 07-02-2015, 12:23 PM
RE: A PITA recap job - by OldRestorer - 07-02-2015, 03:55 PM
RE: A PITA recap job - by Radioroslyn - 07-05-2015, 09:53 PM
RE: A PITA recap job - by sam - 07-05-2015, 10:30 PM
RE: A PITA recap job - by morzh - 07-06-2015, 10:09 AM
RE: A PITA recap job - by sam - 07-06-2015, 11:45 AM
RE: A PITA recap job - by Radioroslyn - 07-06-2015, 12:41 PM
RE: A PITA recap job - by sam - 07-06-2015, 12:50 PM
RE: A PITA recap job - by morzh - 07-06-2015, 01:19 PM
RE: A PITA recap job - by Radioroslyn - 07-06-2015, 04:54 PM
RE: A PITA recap job - by morzh - 07-06-2015, 07:06 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 4531 online users. [Complete List]
» 2 Member(s) | 4529 Guest(s)
AvatarAvatar

>