American Bosch 5AC

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

American Bosch 5AC

dseverson
Member

Posts: 101
Threads: 11
Joined: Nov 2014
City: Castro Valley, CA

#16

07-04-2015, 03:24 PM

No hum on pin 3 of 47.

I think the power transformer is bad. Can't get a steady reading on any of it and I don't get any readings on the other tubes.

Find

« Next Oldest | Next Newest »

Messages In This Thread

American Bosch 5AC - by dseverson - 06-16-2015, 03:29 PM

RE: American Bosch 5AC - by dseverson - 06-16-2015, 03:31 PM

RE: American Bosch 5AC - by jerryhawthorne - 06-16-2015, 04:05 PM

RE: American Bosch 5AC - by dseverson - 06-16-2015, 04:09 PM

RE: American Bosch 5AC - by Radioroslyn - 06-16-2015, 06:37 PM

RE: American Bosch 5AC - by jerryhawthorne - 06-16-2015, 08:20 PM

RE: American Bosch 5AC - by Radioroslyn - 06-16-2015, 09:24 PM

RE: American Bosch 5AC - by dseverson - 06-16-2015, 10:40 PM

RE: American Bosch 5AC - by jerryhawthorne - 06-16-2015, 10:59 PM

RE: American Bosch 5AC - by dseverson - 06-16-2015, 11:56 PM

RE: American Bosch 5AC - by dseverson - 06-17-2015, 12:13 AM

RE: American Bosch 5AC - by Arran - 06-17-2015, 02:55 AM

RE: American Bosch 5AC - by dseverson - 06-18-2015, 10:02 PM

RE: American Bosch 5AC - by dseverson - 07-04-2015, 05:38 AM

RE: American Bosch 5AC - by Radioroslyn - 07-04-2015, 06:33 AM

RE: American Bosch 5AC - by dseverson - 07-04-2015, 03:24 PM

RE: American Bosch 5AC - by Radioroslyn - 07-04-2015, 06:10 PM

RE: American Bosch 5AC - by dseverson - 07-04-2015, 11:17 PM

RE: American Bosch 5AC - by Radioroslyn - 07-05-2015, 09:37 PM

RE: American Bosch 5AC - by dseverson - 07-05-2015, 11:07 PM

RE: American Bosch 5AC - by Radioroslyn - 07-05-2015, 11:26 PM

RE: American Bosch 5AC - by dseverson - 07-06-2015, 01:13 PM

RE: American Bosch 5AC - by jerryhawthorne - 07-06-2015, 01:51 PM

RE: American Bosch 5AC - by dseverson - 08-07-2015, 05:27 AM

RE: American Bosch 5AC - by Radioroslyn - 08-09-2015, 09:21 AM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

Who's Online

There are currently 5424 online users. [Complete List]
» 2 Member(s) | 5422 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me