Grunow 654

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Grunow 654

vecher
Phorum Expert

Posts: 933
Threads: 140
Joined: Mar 2015
City: Lansdale State, Province, Country: PA

#22

07-04-2015, 11:37 PM

I measured -.5 volts using my Old Military VTVM TS-505.

According to schematic it should be -.2 Volts..

[Image: http://i292.photobucket.com/albums/mm38/...szm6qw.jpg]

These radio were run on 110 Volts AC I think so with my voltage higher it should be more?? The B+ should be around 250 Volts I measure about 330 volts.. I have a transformer I use on my 390's to step down the voltage .. I guess I will hook it up to radio to see what I get..

Anyway Radio work great..

Skip...

Find

« Next Oldest | Next Newest »

Messages In This Thread

Grunow 654 - by vecher - 06-22-2015, 12:36 AM

RE: Grunow 654 - by Arran - 06-22-2015, 03:13 AM

RE: Grunow 654 - by Radioroslyn - 06-22-2015, 07:03 AM

RE: Grunow 654 - by vecher - 06-22-2015, 06:38 PM

RE: Grunow 654 - by vecher - 06-22-2015, 10:35 PM

RE: Grunow 654 - by Arran - 06-23-2015, 01:26 AM

RE: Grunow 654 - by Warren - 06-22-2015, 11:46 PM

RE: Grunow 654 - by jerryhawthorne - 06-23-2015, 12:17 AM

RE: Grunow 654 - by mikethedruid - 06-23-2015, 12:55 AM

RE: Grunow 654 - by vecher - 06-23-2015, 09:51 AM

RE: Grunow 654 - by vecher - 06-23-2015, 08:18 PM

RE: Grunow 654 - by Arran - 06-24-2015, 12:57 AM

RE: Grunow 654 - by codefox1 - 06-24-2015, 08:17 AM

RE: Grunow 654 - by vecher - 06-24-2015, 03:23 PM

RE: Grunow 654 - by Arran - 06-25-2015, 01:45 AM

RE: Grunow 654 - by jerryhawthorne - 06-24-2015, 03:50 PM

RE: Grunow 654 - by vecher - 06-24-2015, 04:14 PM

RE: Grunow 654 - by vecher - 06-26-2015, 04:57 PM

RE: Grunow 654 - by vecher - 07-04-2015, 04:52 PM

RE: Grunow 654 - by Radioroslyn - 07-04-2015, 05:58 PM

RE: Grunow 654 - by vecher - 07-04-2015, 08:57 PM

RE: Grunow 654 - by vecher - 07-04-2015, 11:37 PM

RE: Grunow 654 - by Arran - 07-05-2015, 02:12 AM

RE: Grunow 654 - by vecher - 07-05-2015, 10:51 PM

RE: Grunow 654 - by Arran - 07-06-2015, 03:06 AM

RE: Grunow 654 - by vecher - 07-06-2015, 10:05 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me