1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Unknown Philco Tombstone Cabinet
Crist Rigotti
Senior Member
****
Posts: 384
Threads: 22
Joined: Mar 2015
City: Waxahachie, TX
#8

07-06-2015, 09:23 AM
(07-06-2015, 03:54 AM)Arran Wrote:   If that cabinet were cheap enough I would buy it if I ran across it, for cabinet parts. My Philco 620's cabinet was the victim of a moron with a disk and a drum sander, with which they mutilated the poplar millwork on either side of the front control panel.
Regards
Arran

Yes, a good point!
Crist
Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: Unknown Philco Tombstone Cabinet - by KCMike - 07-05-2015, 05:04 PM
RE: Unknown Philco Tombstone Cabinet - by Arran - 07-06-2015, 03:54 AM
RE: Unknown Philco Tombstone Cabinet - by Crist Rigotti - 07-06-2015, 09:23 AM
RE: Unknown Philco Tombstone Cabinet - by AI2V - 07-13-2015, 03:20 PM



Users browsing this thread: 6 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Rod, My radio is run 7. The wave trap is on that schematic as shown in the picture. dconant — 09:21 AM
American Bosch Model 802 auto radio
Hi Arran ,  Thanks for your help with this radio.And especial thanks for letting me know to look it up under United Ame...Antipodal — 04:32 AM
Philco 60 Squealing
Usually a wave trap is for keeping IF signals from entering the antenna and from leaving the antenna. You feed an IF sig...RodB — 09:30 PM
Philco 60 Squealing
I just peaked it for the best signal at 600. NULL it for IF frequency, originally it would have been null for 500kh...Chas — 08:05 PM
Philco 60 Squealing
Wavetrap no longer matters.morzh — 05:19 PM
Philco 60 Squealing
Rod, I had checked out your suggestions but did not help. I did solder the ground rivets to the chassis as Chas suggeste...dconant — 04:52 PM
37-690 Bass Choke Replacement
Yeah, I know, Mouser and Digikey don't have "big iron" components. For some reason Philco was messing with the...Radiodial — 04:25 PM
37-690 Bass Choke Replacement
Yes, I just had to deal with that while repairing the 37-604 Philco. Exactly that value choke was gone. And the current ...morzh — 03:52 PM
37-690 Bass Choke Replacement
Ah, now where to find one. I've into this before on smaller sets, I now recall. Hammond makes one that is only rated...Radiodial — 03:27 PM
Philco 38-7 Speaker
Ask the admins to put them together. As for the renaming, while inside the thread, you simply press "New reply&quo...morzh — 02:23 PM

[-]
Who's Online
There are currently 5042 online users. [Complete List]
» 1 Member(s) | 5041 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios