Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA 8t plays again/REDO DIAL
#16

(07-09-2015, 10:13 AM)Dan Walker Wrote:  I think it looks better now that you have changed the color of the escutcheon.  It looks more original.
   Nice job on the cabinet

Thanks Dan, some guys were telling me the escutcheon was polished from factory, after researching a little I don't think it was so I went ahead and darkened it, looks a lot better.


Messages In This Thread
RCA 8t plays again/REDO DIAL - by Fred Taylor - 07-05-2015, 09:45 AM
RE: RCA 8t plays again - by Fred Taylor - 07-05-2015, 09:49 AM
RE: RCA 8t plays again - by Crist Rigotti - 07-05-2015, 10:33 AM
RE: RCA 8t plays again - by Fred Taylor - 07-05-2015, 02:57 PM
RE: RCA 8t plays again - by jerryhawthorne - 07-05-2015, 03:50 PM
RE: RCA 8t plays again - by SteveG - 07-05-2015, 05:03 PM
RE: RCA 8t plays again - by Fred Taylor - 07-05-2015, 08:10 PM
RE: RCA 8t plays again - by Ron Ramirez - 07-05-2015, 08:32 PM
RE: RCA 8t plays again - by Phlogiston - 07-06-2015, 01:15 AM
RE: RCA 8t plays again - by Arran - 07-06-2015, 02:36 AM
RE: RCA 8t plays again - by PhilcoJohn - 07-07-2015, 07:00 AM
RE: RCA 8t plays again - by morzh - 07-07-2015, 09:45 AM
RE: RCA 8t plays again/REDO DIAL - by Arran - 07-09-2015, 05:39 AM
RE: RCA 8t plays again/REDO DIAL - by Fred Taylor - 07-08-2015, 05:26 PM
RE: RCA 8t plays again/REDO DIAL - by Dan Walker - 07-09-2015, 10:13 AM
RE: RCA 8t plays again/REDO DIAL - by Fred Taylor - 07-09-2015, 10:20 AM
RE: RCA 8t plays again/REDO DIAL - by SteveG - 07-10-2015, 04:57 PM
RE: RCA 8t plays again/REDO DIAL - by Fred Taylor - 07-12-2015, 08:06 PM
RE: RCA 8t plays again/REDO DIAL - by kj0002 - 07-11-2015, 08:47 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 6340 online users. [Complete List]
» 3 Member(s) | 6337 Guest(s)
AvatarAvatarAvatar

>