1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
16b and model 20 pwr trans
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#13

02-18-2009, 06:11 AM
The cabinet is indeed a 16B...but I'd never seen a 5-band chassis in this cabinet before, only in the cathedral and the version of this cabinet with the less pronounced peak to the cabinet top.

Did you buy this radio? If so, tell me, is there a large hole behind the tuning knob? If so...then, definitely, the chassis has been switched. The 4-band version uses dual concentric tuning knobs, necessitating the large hole for the larger concentric tuning shafts. A 5-band chassis where a 4-band chassis should be...a 5Z3 in place of an 80...this points to a chassis swap to me.
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »


Messages In This Thread
16b and model 20 pwr trans - by philco phan - 02-16-2009, 04:50 PM
Re: 16b and model 20 pwr trans - by Steve Davis - 02-16-2009, 05:52 PM
Re: 16b and model 20 pwr trans - by Ron Ramirez - 02-16-2009, 05:53 PM
Re: 16b and model 20 pwr trans - by philco phan - 02-16-2009, 06:25 PM
Re: 16b and model 20 pwr trans - by philco phan - 02-16-2009, 09:34 PM
Re: 16b and model 20 pwr trans - by Steve Davis - 02-16-2009, 09:58 PM
Re: 16b and model 20 pwr trans - by Ron Ramirez - 02-16-2009, 10:56 PM
Re: 16b and model 20 pwr trans - by philco phan - 02-16-2009, 11:08 PM
Re: 16b and model 20 pwr trans - by philco phan - 02-17-2009, 12:28 AM
Re: 16b and model 20 pwr trans - by philco phan - 02-17-2009, 10:05 PM
Re: 16b and model 20 pwr trans - by Ron Ramirez - 02-17-2009, 11:06 PM
Re: 16b and model 20 pwr trans - by philco phan - 02-18-2009, 12:24 AM
Re: 16b and model 20 pwr trans - by Ron Ramirez - 02-18-2009, 06:11 AM
Re: 16b and model 20 pwr trans - by philco phan - 02-18-2009, 06:00 PM
Re: 16b and model 20 pwr trans - by philco phan - 02-18-2009, 07:46 PM
Re: 16b and model 20 pwr trans - by radiomikee - 02-27-2009, 12:13 PM
Re: 16b and model 20 pwr trans - by philco phan - 02-28-2009, 12:03 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration