Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Info on 40-170CS
#10

(07-23-2015, 08:21 AM)Patrick Wrote:  I'll take a post some pics today as I start disassembly. You will notice that the top 2 inlays are bird's eye maple, which was installed by the OP. I'll be replacing these with book match burl, either mahogany or walnut.

 I would leave the birdseye in there, believe it or not Philco did make some cabinets using figured maple. I can't say that this was factory built but if it was not it was very professionally done if it wasn't.
Regards
Arran


Messages In This Thread
Info on 40-170CS - by Patrick - 07-22-2015, 09:26 PM
RE: Info on 40-170CS - by shaler78 - 07-22-2015, 09:34 PM
RE: Info on 40-170CS - by klondike98 - 07-22-2015, 09:36 PM
RE: Info on 40-170CS - by Patrick - 07-23-2015, 08:21 AM
RE: Info on 40-170CS - by Arran - 07-24-2015, 06:44 AM
RE: Info on 40-170CS - by Patrick - 07-24-2015, 09:04 AM
RE: Info on 40-170CS - by TA Forbes - 07-23-2015, 11:18 AM
RE: Info on 40-170CS - by Patrick - 07-23-2015, 02:25 PM
RE: Info on 40-170CS - by klondike98 - 07-23-2015, 05:47 PM
RE: Info on 40-170CS - by TA Forbes - 07-23-2015, 07:39 PM
RE: Info on 40-170CS - by NN7X - 07-23-2015, 08:23 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
I'm starting to restore a Philco 16X, I need spare parts. Help me find it
Michael, this is one of the five radio consoles from Canada from my companion that I received for restoration and that I...RadioSvit — 10:16 AM
What is this?
You can probably save it using coils on the wire leads. Try unwinding a tad off each end of the rf coil.RodB — 09:47 PM
What is this?
Yes, thanks.  I kinda figured that out LOL.    I thought I knew what it was until I cut it out.  Coulda, woulda, shoulda...MissouriLarry — 08:35 PM
I'm starting to restore a Philco 16X, I need spare parts. Help me find it
Where did you get this one from? I have restored same exact 16X about 2 years ago, the thread is here. morzh — 06:29 PM
What is this?
Before yanking anything, especially if you don't know what it is, find out what it is. As Rod said, it is an RF coil. H...morzh — 06:26 PM
What is this?
Solder it back in, I can't find it on the schematic but it's probably an rf choke. You should identify parts in the sch...RodB — 03:39 PM
Philco 42-345 Restoration/Repair
Thank you Radiorich unless someone else chimes in I will try and message Just Radios and hopefully they will have an ans...osanders0311 — 09:58 PM
Philco 42-345 Restoration/Repair
Hello Osanders, I even looked that product up on just radio they must have secret design . I can't find a part number ...radiorich — 08:24 PM
Philco 42-345 Restoration/Repair
Hello guys I ordered and received a capacitor from just radios and can't figure out which side is the pos/neg terminal. ...osanders0311 — 05:35 PM
I'm starting to restore a Philco 16X, I need spare parts. Help me find it
I'm preparing an old Philco 16X radio console from 1934 for restoration, which unfortunately is in pretty bad condition,...RadioSvit — 04:15 PM

[-]
Who's Online
There are currently no members online.

>