Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Grandfather clock radio combo
#4

Hi
Thanks for the reply.

I took a look at the chassis you mentioned and it appears not to be match, unless there are variations.

Here is a photo of one online.

http://www.tuberadioland.com/images/phil37-10t_4_.jpg

Have another idea on the radio?

Appears to have 2 output transformers?

There may be a chassis number on it but it's not readable on the photos available.

What brands of grandfather electric clock radios were there?

I'm wondering if the original radio died and it was replaced with a philco as a repair or an enhancement.


The owner claims it has a sessions clock. Again could have been replaced.


Messages In This Thread
Grandfather clock radio combo - by thinktreasure - 07-31-2015, 01:20 PM
RE: Grandfather clock radio combo - by thinktreasure - 08-01-2015, 11:57 AM
RE: Grandfather clock radio combo - by sam - 08-01-2015, 04:30 PM
RE: Grandfather clock radio combo - by AI2V - 08-01-2015, 10:12 PM
RE: Grandfather clock radio combo - by AI2V - 08-02-2015, 09:43 PM
RE: Grandfather clock radio combo - by codefox1 - 08-14-2015, 09:32 AM
RE: Grandfather clock radio combo - by wa2ise - 08-15-2015, 09:25 AM
RE: Grandfather clock radio combo - by sam - 09-11-2015, 03:00 AM
RE: Grandfather clock radio combo - by codefox1 - 09-15-2015, 03:31 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2263 online users. [Complete List]
» 2 Member(s) | 2261 Guest(s)
AvatarAvatar

>