Do I have a 37-60 or 37-61?

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Guest
Unregistered

02-22-2009, 02:00 PM

I have a Philco that I restored years ago and I am now working on it again. The cabinet sticker says it is a 37-60, but I think the chassis is a 37-61. How do you tell what chassis it is? I can't find any stickers on the chassis. The chassis tunes broadcast and shortwave 6-18 Mhz. I have a 37-61 schematic, which makes me think I considered it a 37-61 when I bought the schmatic. I have another similar cabinet and I may have mixed them up.

« Next Oldest | Next Newest »

Messages In This Thread

Do I have a 37-60 or 37-61? - by Guest - 02-22-2009, 02:00 PM

Re: Do I have a 37-60 or 37-61? - by exray - 02-22-2009, 02:08 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

Who's Online

There are currently 6191 online users. [Complete List]
» 6 Member(s) | 6185 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me